Introduction

This guide will assist you in replacing your side mirror if it is broken or shakes.

  1. nSd16h2VyPgDbL2s
    nSd16h2VyPgDbL2s
    Fm3W3wKtfVOjqnDC
    qLGDNBosluTAFHoW
    • Unscrew the two T25 Screws located on the sides of the mirror.

    • The mirror should be bolted inside (which we will get to later), so the mirror should not fall.

  2. OQcpxMiOCPOrWSLp
    OQcpxMiOCPOrWSLp
    bRbMIxWNpJsHnMbK
    wAp1JPSpTO1cIhXK
    • Inside the door panel, there are two Philips screws. One in the panel's upper right side, the other inside the door pull. Remove both.

  3. fj31FVBCD6vTncuM
    fj31FVBCD6vTncuM
    3uDhwPajcteUXjGu
    XNBAbNxqysYyUQAs
    • Turn the crank handle until the knob is facing upward. Using a hook pick or a small flathead screwdriver, gently pry open the front cover.

    • Rotating the cover out of your way, unscrew the T20 screw from inside the handle.

    • To avoid losing the screw, slide the cover back over the handle without fully removing it. However, make sure not to clamp it closed.

  4. wM2f55ovYFKbw1Zp
    wM2f55ovYFKbw1Zp
    GPOBjmShhfsIeRrF
    4Qkw2NDMttVcYHYd
    • Three plastic retaining clips are located at the bottom of the panel. To remove those clips, either use a fastener removal tool or your hands.

    • Release the door panel from the door lock by lifting it up. To clear the door handle, move the door panel to the right.

  5. yDVnTQkAlqOxfinB
    yDVnTQkAlqOxfinB
    WtLeUfLhPyKQvy3H
    • With the panel removed. Locate the 10 mm bolt near the speaker at the top. Using a 10 mm socket, loosen the bolt.

    • Keep one hand on the mirror to prevent it from falling. This will remove the mirror from the truck.

  6. SYQPYDyVXrqFfXYy
    SYQPYDyVXrqFfXYy
    6pt13ShjpdXL5skg
    • To remove the mirror, lift up and to the left to clear the arm inside the door.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Rachelcall

Member since: 27/06/23

133 Reputation

0 comments