Introduction

This is the ASUS Chromebook (Model C424MA-DH48F), here we will be guiding you though a full battery replacement for the ASUS Chromebook.

Reasons to replace the battery include:

  • Overheating
  • Reduced battery life
  • Slow charging
  • Swollen battery
  • Laptop dying unexpectedly

After replacing the component if you plan on disposing of the old battery here is a link explaining proper battery disposal.

  1. 1iAVSKtaUPx3sbbb
    1iAVSKtaUPx3sbbb
    dPqU6xH3TK2y3FJM
    • Use a Phillips #0 screwdriver to remove the eleven 6.9 mm screws that secure the lower case.

    • Make sure all the screws on this side get taken out because there could be a label or warranty sticker covering up a screw that might be missed.

    • Insert an opening pick into the gap between the lower case and chassis.

    • Slide the pick around the entire perimeter of the laptop until the lower case fully releases.

    • Remove the lower case.

    There is one screw not listed in the guide. It is located under the rubber foot in the upper left corner of the first photo

    Michael -

  2. 3A6hZNCAcamCd52g
    3A6hZNCAcamCd52g
    dWTegYJKs1qLoGNW
    RQYbBGRTK4qM2QF1
    • Use an opening tool to pop up the silver locking bar securing the battery connector.

    • Push the battery connector directly out of its motherboard port.

  3. TuSxCo2RZ3ZjVXnL
    TuSxCo2RZ3ZjVXnL
    fa56lglqHTcZNXFh
    WuQuneMtH1lvJqZT
    • Carefully use the plastic prying tool and pop up the locking bar and lift the connector off with your hand.

  4. pRPHQpoCsxfdeEe6
    pRPHQpoCsxfdeEe6
    VWwBIclGHAoS2BTr
    qALVmtMLDo1I1nq1
    • Use a Phillips #0 screwdriver to remove the six 4.1 mm screws that secure the battery.

    • The two screw holes (marked in orange) on the bottom won't have screws associated with them since they were removed earlier when the base was removed.

    • Unseat the speaker cable from the black plastic hooks on the lower side of the battery.

    • Lift the battery up and out of the chassis.

Conclusion

To reassemble your device, follow the above steps in reverse order.
For optimal performance, after completing this guide, calibrate your newly installed battery.
Take your e-waste to an R2 or e-Stewards certified recycler.

Anthony Wink

Member since: 28/08/24

401 Reputation

0 comments