Acer Iconia B1-A71 LCD Display Replacement

Written By: ZFix
  • Comments: 2
Acer Iconia B1-A71 LCD Display Replacement

Difficulty

Moderate

Steps

5

Time Required

15 - 20 minutes

Introduction

The video is for fully disassemble the tablet, but you can follow the steps until the separating the LCD display.


Please SUBSCRIBE to my channel ツ

  1. 1NKVALUOCPUCwKat
    1NKVALUOCPUCwKat
    aXu4ayIkaByr5ogc
    I4PVAg1YR2HfpDRY

    • Switch-off the tablet.

    • If you can't switch it off, use the reset button to do this.

    • With a cutter and a plastic tool remove the back cover.

    • If you have a memory card inside, don't forget to remove it!

  2. GwUIK1hmb2VUGXjW
    GwUIK1hmb2VUGXjW
    FeivkDUlB6L43qGO

    • First, disconnect the battery.

    • Now, disconnect the loudspeaker and remove the back cover.

    • Remove all scotch tapes and disconnect the touch screen flex cable...

    • LCD display flex cable,

    • the microphone,

    • and the WiFi and Bluetooth antennas flex cables.

  3. 2UTeTtuFxBSTXQ61
    2UTeTtuFxBSTXQ61
    Rvgex6vKJHeUNPAd
    dbKYZR2sfAmjWVt1

    • Unscrew 5x screws and rmove the main board.

    What type of screws does it uses?

    Damian Hakim Moncal -

  4. dpcYgiN1ROiu6F3V
    dpcYgiN1ROiu6F3V
    gNQAI2KlheLvqClS
    1WsrG6oPOnwc6QBM

    • The battery is glued to the LCD display metal shield with a double sided adhesive tape.

    • Use plastic tools and carefully remove it.

    • Remove all tapes from the LCD display metal shield.

  5. FYbgDJIPWRB14iZs
    FYbgDJIPWRB14iZs
    fmgM4JN14SEOBHqA
    rlHcJmIVbaKmfHLb

    • The LCD display is held by metal frame and some locking clips on it.

    • Use a cutter and a plastic tool to separate the LCD.

    • You have to work slowly so as not to break the display.

    • Now, install the new LCD display and reassemble the tablet.

    • .

    • Did you do it successfully?

    • Please SUBSCRIBE to my channel ツ

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

ZFix

Member since: 09/12/13

194093 Reputation

One comment

Iconia B1-A71 SNID 30313237615, MB KO, Battery out, display are good. I would like to use the display with Arduino shield, even without Touch control. There is a shield that can connect the flat of the display and maybe, but not essential, that of the touch?

Thanks.

Maurilio Fiorito -