Introduction
Replacing the motherboard in an Anker Soundcore Motion Boom A3118 requires disassembling the speaker and carefully disconnecting internal components. This step-by-step guide will take you through the process, from removing the outer casing to installing the new motherboard. Be sure to follow the instructions carefully to avoid damaging any other internal parts and ensure the new motherboard is properly connected. With the right tools and patience, you can restore full functionality to your Soundcore Motion Boom.
-
-
Use the metal spudger to remove the left and right shells surrounding the subwoofer.
-
Use the metal spudger to remove the front speaker grille.
-
-
-
Remove eight 15 mm screws located in the four corners of each front speaker using a Phillips #1 screwdriver.
-
-
-
Remove all eight internal 15 mm screws from around the front speakers using a Phillips #1 screwdriver.
-
-
-
Tear off the padding on the top of the speaker with your hands.
-
Remove the three 15 mm screws located on the top of the speaker using a Phillips #1 screwdriver.
-
-
-
Disconnect the speaker's white power cord from the motherboard.
-
Disconnect the rest of the cords connected to the motherboard.
-
-
-
Remove the three 15 mm screws using a Phillips #1 screwdriver from the bottom left and right sides of the motherboard.
-
Remove the entire motherboard from the speaker.
-
-
-
Remove the five 10 mm screws from the motherboard using a Phillips #0 screwdriver.
-
Separate the battery from the motherboard.
-
To reassemble your device, follow these instructions in reverse order.
