Beats Solo Pro Side panel Replacement

Written By: HelloMacOS
  • Comments: 1
Beats Solo Pro Side panel Replacement

Difficulty

Moderate

Steps

4

Time Required

30 minutes

Introduction

This guide will show you how to replace the side panel on your Beats Solo Pro

  1. Nvi2OvXksErU6UdC
    Nvi2OvXksErU6UdC
    u3f2VYIWVIJOEGeE

    • Slide the headphones down to extend the hinge.

  2. DwFd1wDiFAZEpjif
    DwFd1wDiFAZEpjif
    VhXdim2eCkTwcSHZ

    • Once extended insert a prying the new gap to unclip the panel

    • Once unclipped repeat on the other side of the panel

    • The two clips are towards the top of the panel, as indicated by the location of the metal prying tool in the image.

  3. RBFLjIDZxrJhqlEj
    RBFLjIDZxrJhqlEj
    CmeldkFR1Et5orRm

    • Slide the panel down and lift away from the headphone just until its separated

    • Don't pull the plastic piece offs there is still cables attached to it

  4. CBSrYdwYToyadeUk
    CBSrYdwYToyadeUk
    XorgvVSwioo4nkpb

    • If needed tighten the PH00 screw(if your side panel has came loose on it own you will need to do this to fix the issue)

    • If you want to replace the side panel you will need to carefully pry the cables out from where they are glued in and glue them in to the new panel(refer to second image)

Conclusion

To reassemble complete steps in reverse:-)

Author

HelloMacOS

Member since: 24/01/22

26640 Reputation

One comment

Muchas gracias por tus pasos a seguir.
Yo tengo un problema pero con el tornillo que esta tapado por los cables, al cual no puedo acceder para poderlo apretar contra la tapa exterior.

Alfredo Olvera -