Boss CE-300 Super Chorus Fuse Replacement

Written By: Rashed
  • Comments: 0
Boss CE-300 Super Chorus Fuse Replacement

Difficulty

Moderate

Steps

4

Time Required

20 - 30 minutes

Introduction

You may have issues getting your BOSS CE-300 SuperChorus to power on. You may be able to fix the issue within 10 minutes by replacing a fuse. The only tools needed are a Phillips #2 screwdriver and a plastic pry tool. ​

  1. qu2IYLRYgML41SAj

    • Remove the following screws with a Phillips #2 screwdriver:​

    • Two 7.5 mm

    • Two 10 mm

  2. CILmbQRQQNlsM1Gx
    CILmbQRQQNlsM1Gx
    cL1oZrEgMf6QYkX1

    • Lift the bottom panel up and off.

  3. Rxlop44yRGriZwHC
    Rxlop44yRGriZwHC
    LXMnByrTxVCGqkhN

    • Once the bottom plate is removed, you have clear access to the fuse shown​.

    • Optional: To test the fuse, use a multimeter in the continuity setting. ​ Place the probes on each end of the fuse (polarity does not matter), if the fuse is good, the multimeter should beep.​

  4. aU3byTrE1mDCprHi
    aU3byTrE1mDCprHi
    IKuvLynlTCbU6WRY

    • Use an opening tool to carefully remove the fuse. ​ ​

    • Avoid using metal tools near the motherboard. Any accident could break more complex components. ​

    • You may visually inspect the fuse and compare it to a replacement 0.5A fuse.

Conclusion

To reassemble your device, follow the above steps in reverse order.
Take your e-waste to an R2 or e-Stewards certified recycler.
Repair didn’t go as planned? Try some basic troubleshooting or ask our Answers community for help.

Author

Rashed

Member since: 25/09/24

285 Reputation

0 comments