Casio CZ-1000 Display Screen Replacement

Written By: Ayman Benbrahim
  • Comments: 0
Casio CZ-1000 Display Screen Replacement

Difficulty

Moderate

Steps

6

Time Required

30 minutes

Introduction

If your display screen is not turning on or is malfunctioning then use this guide to replace your display screen on you Casio CZ-1000 synthesizer. The display screen is significant part of this synthesizer that allows you to save memory to a RAM cartridge, load RAM cartridges, and change the tone of your synthesizer. In this guide you will be provided with a step by step process on how to replace you display screen.

  1. AxavRoIe5aKFUVFZ
    AxavRoIe5aKFUVFZ
    QHLSMuQMkEX5gJGm

    • Use a Phillips #1 screwdriver to remove the eleven 7.5 mm screws securing the back plate.

  2. 3gI6qEMThnraVaOv
    3gI6qEMThnraVaOv
    xYmHXiL5RYgesGQt
    6CBlwtt5NAsdgU4H

    • Using a Phillips #1 screwdriver, remove all 14 5.5 mm screws from the two motherboards.

    • These screws secure the motherboards to the keyboard assembly and the dial on the right side.

  3. q6HpFPuKTFWmwySS
    q6HpFPuKTFWmwySS
    biNQkYLF1dP5IGQh
    TWOZcGK3kQCs5ER5

    • Carefully cut the zip tie located in the right-hand corner using a pair of scissors or wire cutters.

    • Be sure to avoid cutting any nearby wires or components.

    • Gently slide all the plugs out of their sockets.

    • This will prevent them from catching on anything or damaging the connectors as you lift.

  4. 1LZEryhhJvsCkNe6
    1LZEryhhJvsCkNe6
    MeLaGp3UKXFeBukA

    • Pull out the orange 24 pin connector.

    • Pull on the orange plastic piece and not the wires. Pulling on the wires can potentially damage the device.

  5. GGDYZ3PtSsIgNxYb
    GGDYZ3PtSsIgNxYb
    wWjMVreJVt5APQWU

    • Remove the four 7.5 mm screws that are holding down the metal sheets using a Phillips #1 screwdriver.

    • Set the sheet to the side for now.

  6. kMNfgMj6iU5bCW5s
    kMNfgMj6iU5bCW5s
    hIZNo3GkFUeaAnft
    23LPtAvvOHEd6IqQ

    • Remove the four 5.5 mm screws from the corners of the display screen using a Phillips #1 screwdriver.

    • Lift the side of the display screen that is closer to you and then pull out the screen.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Ayman Benbrahim

Member since: 24/10/24

97 Reputation

0 comments