Introduction

  1. 3tGPcJAErYfGAAxL
    • Flip the device upside down and remove all of the Phillips #1 screws.

  2. VuMqQDbboHyCsgkA
    VuMqQDbboHyCsgkA
    RYGAyDsIait5XEmk
    • Use an opening tool to push on the retaining hooks to disengage them while prying slightly.

    • Remove the panel.

  3. rB3xHqQuMDEjQ5yO
    • Use a Phillips #1 screwdriver to remove all four screws.

    • Lift off the bracket.

    • When lifting this off be careful to not unplug the screen.

  4. vQNq4MWMkP5GfljJ
    vQNq4MWMkP5GfljJ
    UY6ulOxoTPwSSi2Q
    • Use a Phillips #0 screwdriver to remove all the screws connecting to the shell.

    • Dissemble the shell going up to separate the basket holder.

  5. bWUhOSYNPqDARLY3
    bWUhOSYNPqDARLY3
    D4QHVXyEqRPjcmqV
    • Use a Phillips #0 screwdriver and the 150 mm Flex Extension to unscrew the bottom plastic connecting to the basket holder.

    • Be careful to not apply too much force to the metal as it can cause it to warp it, and so it is easy rescrew the plastic piece in place.

  6. Y1vO3OCvG2MJQxLI
    Y1vO3OCvG2MJQxLI
    NekqHCsuZSIL6Zgt
    • Pull the bottom shell down pulling at the sides to get them over screw holes.

  7. NqIq351OGRVKkHMy
    NqIq351OGRVKkHMy
    VuvlHtWapTAHSCQV
    • Depress the white clip and disconnect the screen connector.

  8. hxDAYaViaaAn26Zy
    hxDAYaViaaAn26Zy
    IBCYDWbFURNtYaIa
    • Remove the plastic panel.

  9. NnKsmFHcODhfMpEB
    • Remove the two screws with a Phillips #1 screwdriver.

  10. paEypeBPqTIpDkaw
    paEypeBPqTIpDkaw
    4NyVkK1xdRLrGaUs
    OcXZrrA4qUKUirHt
    • Apply force simultaneously to the four hooks to release the mother board.

    • Using a prying tool pull out the springs on the mother board from their sockets.

    • Remove the motherboard.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Andrew Levonius

Member since: 28/08/24

121 Reputation

0 comments