Introduction
The Cub Cadet Z-Force 48 riding lawn mower (engine model SV8205) requires an oil change annually or every 100 hours of use-whichever comes first. Changing the oil at home can be simple with the correct tools, and can save you time and money by not needing to take your lawn mower to a mechanic.
Your Cub Cadet owner's manual will specify the type of oil and oil filter your engine will need. If you do not have access to an owner's manual, please use the tools and parts listed. To learn how to change the oil on a Cub Cadet Z-Force 48 lawn mower, please read the following steps. Before starting, please ensure the engine is cool to avoid to burns.
Tools
Parts
-
-
Hold the tip of the oil drain hose with the closed end of a 3/4-inch combination wrench.
-
Use the open end of the 1/2 inch combination wrench to loosen the oil drain plug.
-
Finish loosening the drain plug with your hands and remove it.
-
-
-
Reinsert the drain plug and tighten it with the open end of a 1/2-inch combination wrench.
-
Use a torque wrench to tighten 13.6 N·m (10 ft. lb.).
-
-
-
Place paper towels or an old rag under the old oil filter to catch any excess oil.
-
Remove the old oil filter.
-
-
-
Replace the soiled paper towels underneath the oil filter mount.
-
Wipe the oil filter mount clean with paper towels.
-
-
-
Install the new oil filter, hand tightening the filter clockwise.
-
Tighten the oil filter until the rubber gasket contacts the oil filter mount, then tighten an additional 3/4-1 turn.
-
-
-
Remove the oil fill cap.
-
Fill the engine with the amount and type of oil specified in your owner's manual.
-
Put the oil fill cap back into place.
-
-
-
Start the engine and check for leaks.
-
Stop the engine and allow the oil to drain down.
-
Remove the oil fill cap and check the dipstick to ensure that the oil is to the full mark.
-
Please check your local regulations to ensure proper disposal of oil.
