D-Link DCS-825L Antenna Replacement

Written By: Alexis Clopton
  • Comments: 0
D-Link DCS-825L Antenna Replacement

Difficulty

Moderate

Steps

10

Time Required

7 minutes

Introduction

There are times that the antenna of the Wi-Fi Baby Camera does not work. This is a step by step guide on how to remove a faulty antenna from the Wi-Fi Baby Camera and replacing it with a working antenna.

  1. XGKdsa2TSXclGCXx

    • Grasp the side of the accent ring. There is a notch that your thumb will be able to grab ahold of.

  2. JljsHh2jFKWKXBDy

    • Twist the accent ring until it pops off. You may need to use both hands if the accent ring is stuck.

  3. HODEkHI5S1L6BfCw

    • Replace your accent ring with whichever color you choose.

  4. SMHDeDxQwtoAE2Rf
    SMHDeDxQwtoAE2Rf
    n5TexVVBVdXDgHtG

    • Remove one Phillips #2 screw from each side of the camera lens.

  5. TK1BmbAVHBVtmrpB
    TK1BmbAVHBVtmrpB
    JE1pIIggBY5hNOwP
    VLLgRPiMLKtQtCHZ

    • Pull the Wi-Fi Baby Camera open.

    • It should be easily done after the screws are removed.

  6. XChP4STHxZT11fd4
    XChP4STHxZT11fd4
    6KTKUWfLBeGVCKXg

    • Take your tweezers and gently pull the white tip out from its plug that is connected to a red and black twisted wire.

  7. OdUGlKnA5ZGudyKG
    OdUGlKnA5ZGudyKG
    ieu4VFcLCihFVcYb
    XBZMUUSroHmaygYQ

    • Take your tweezers and gently pull the white tip that is on the end of the white wire (the antenna) out from its plug in.

  8. vJaMQZdmEYJVwaX2

    • Once you have the back casing removed from the other half of the device, it should look like this with the antenna poking out.

  9. 2NMWwyDoivdjRrsd
    2NMWwyDoivdjRrsd
    jmIMxyCnKnTVM5Ur
    KCOFUfjO6aOOoqij

    • There will be a light yellow rubber stopper that is holding the antenna in place.

    • With your tweezers, gently tug on the stopper to make it come out, or at least come loose.

    • If the stopper does not completely come out, use the round top of the antenna to push down on it.

    • You can do this simply by pulling the antenna as close to the back casing as possible, and then pushing down on it until the rubber stopper comes out completely.

    • After it has come out, it can either be taken off from the antenna and set aside, or it can be kept on.

  10. SPXtAYNZUSexSAx6
    SPXtAYNZUSexSAx6
    YYVL5nPGIOhjpgyX

    • Once the rubber stopper has been pushed out, you will now be able to easily pull the antenna out from the back casing.

    • After it has been removed, you are now able to replace the antenna of your Wi-Fi Baby Camera.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Alexis Clopton

Member since: 09/10/18

97 Reputation

0 comments