DJI Phantom 2 Vision Battery Replacement

Written By: Dylan Ponder
  • Comments: 0
DJI Phantom 2 Vision Battery Replacement

Difficulty

Very easy

Steps

3

Time Required

1 minute

Introduction

This guide demonstrates how to remove and replace the battery in the DJI Phantom 2 Vision. It uses a 5200mAH smart battery. To identify if you have the correct battery use this link to the DJI store page, and make sure all the specifications are the same as the ones listed. If this link is not working, use this one that links to the DJI Phantom 2 Vision manual instead and verify.

Before you begin this repair, make sure your device is powered off and it is disconnected from the charger.

Note: The battery is missing from the device we worked on so we constructed one to demonstrate the removal process.

  1. 25GGJnApOuNRrVgu

    • The battery is located on the backside of the drone. You will see a large rectangular indent protruding outward.

    • The "battery" shown in the image is for illustrative purposes only. Since the original battery was missing, we constructed this one to demonstrate the repair process. The actual battery will not stick out this much.

  2. PhRkfCXxAbGn2TDS
    PhRkfCXxAbGn2TDS
    G5I1dqnbvVFfVKi5

    • Remove the battery from the compartment by pinching the top and bottom pressure points near the center and pulling the battery towards you.

  3. VC6oKKGUSKhb5AUT

    • Clean the battery compartment using cotton swabs and isopropyl alcohol or pressurized air to remove any debris or dust inside.

    • Repeat these steps after every battery replacement to prevent damage to the drone’s internal components.

Conclusion

To reassemble your device, follow these instructions in reverse order. Take your e-waste to an R2 or e-Stewards certified recycler.

Author

Dylan Ponder

Member since: 15/09/24

386 Reputation

0 comments