Introduction
This guide will be used to remove the mobile phone holder on the left side of the DJI Phantom 3 Standard Remote Controller. This will be useful for allowing the holder to remain steady on the controller and offer a support for camera setting on the drone itself.
Caution: The clamp holding the mobile device holder to the metal frame can be difficult to remove without a small level of force. Refrain from using excess force to avoid risk of damaging the part.
Tools
Parts
-
-
Remove the two 9 mm screws from the back of the phone mount using a 2 mm flathead screwdriver.
-
-
-
Grasp the base of the phone mount and unclamp the piece from the metal frame on the outside of the controller.
-
Remove the phone mount.
-
To reassemble your device, follow these instructions in reverse order.
