Disassembling Razer Basilisk X Hyperspeed Top Case

Written By: Toaster Roaster
  • Comments: 1
Disassembling Razer Basilisk X Hyperspeed Top Case

Difficulty

Very easy

Steps

5

Time Required

15 minutes

Introduction

Disassembling the mouse is very easy and should take about 10-15 minutes.

    • First heat up the underside of the device, so the glue of the stickers softens up.

  2. bIGBqLSUXZLAanU6
    bIGBqLSUXZLAanU6
    CKukNqt1ViWN6BjZ
    RKVOEIrmhxdydRVi

    • Use the tweezers to lift the bottom slider, if you use your nails you might just lift the slider, instead of all the glue with the slider.

  3. 6opYEDKFpTBCEZ6S

    • Remove all 4 screws.

    • There is 1 at the bottom under the slider.

    • The top ones are under the letter A from BASILISK and the other one between the EE from HYPERSPEED.

    • The last one is on top of the last 4 digits of the IFETEL number.

  4. LJZfoeplO4svamqE
    LJZfoeplO4svamqE
    FX3ISJZ6WmKRh3AL

    • First remove battery, after that, lift it from the bottom using your nail or a prying tool from the gap at the bottom. Open it carefully, since there are wire connectors. Carefully disconnect from the plastic to avoid damage, DO NOT PULL FROM THE WIRES.

  5. tMsZCSVi3rsqBavE

    • If you need to remove the board, you need a 00 Philips bit, other than that, you have full access to the board.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Toaster Roaster

Member since: 14/04/23

124 Reputation

One comment

rubbish guide.

Dummy Account -