Disassembling Ridgid R86034 Housing

Written By: Nathan Hoyt
  • Comments: 0
Disassembling Ridgid R86034 Housing

Difficulty

Difficult

Steps

6

Time Required

20 minutes

Introduction

Removing the housing to get to the components beneath.

  1. lT32cBph1OcI6aB6

    • Use the flat side of a metal spudger to peel the black rubber cover off of the casing.

    • Use some force; the rubber cover is securely attached to the housing.

    • Rotate the casing until it fits onto the housing with no gaps between it and the clear cover.

    • Make sure the casing is properly oriented onto the housing. Orientation is important here.

  2. muWgkGaPyspu3vLv
    muWgkGaPyspu3vLv
    lVUXByNwbAttLqqc

    • Remove the plastic cover with your hands. It should come off fairly easily.

  3. 1YICKDHLy4yQ5O32
    1YICKDHLy4yQ5O32
    h6rMOCtdXb1aOjmR
    XiwlOyar3drlqZqT

    • Unscrew the four 16 mm long screws from the back panel with a T10 Torx Screwdriver.

    • Use a firm grip to peel off the back panel. It is sealed tight and requires a good amount of force to remove.

  4. xtswKoSbnMsmPsdE
    xtswKoSbnMsmPsdE
    k36RHeRfWN3rBYOg

    • Unscrew the eight 15 mm T10 Torx screws from the housing

    • The screw hole located nearest the battery port is deep and small. Most screwdrivers with replaceable bits will not fit into the hole. Instead, use a conventional screwdriver that fits.

  5. hGfV6lrHXMhM4QsX

    • Place the driver flat on a table before completely separating the two halves of the housing so components of the drill don't fall out during opening.

    • Pry apart the two halves of the housing at the back side of the driver using the metal spudger. The housing is easier to remove if you pry from both sides.

  6. Tnp11lKgGbNPMVIZ
    Tnp11lKgGbNPMVIZ
    eDnlpCdY42LiAb3U

    • Do not remove the direction switch.

    • Pull out all electrical components from housing by hand. The components should require little force to lift out.

    • Lift out the motor.

    • Follow the wires.

    • The circuit board located nearest the battery pack and the LED light will be hard to pull out.

    • Remember to precisely place all components in their correct slots with their correct orientations when reassembling.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Nathan Hoyt

Member since: 20/04/15

244 Reputation

0 comments