EasySMX ESM-9110 Backplate Replacement

Written By: Melanie Rodriguez
  • Comments: 0
EasySMX ESM-9110 Backplate Replacement

Difficulty

Moderate

Steps

6

Time Required

5 - 10 minutes

Introduction

This guide will teach you how to replace the backplate of the EasySMX ESM-9110 controller.

  1. w11ERDQZOBQFg6Nm
    w11ERDQZOBQFg6Nm
    UvIfIvxDUBcZDWwE

    • Use a Phillips #000 screwdriver to remove the two 10 mm screws from the back of controller.

  2. M1MhWsvQ44CAlKrA

    • Insert a plastic opening tool into the slit on the side of controller.

    • Wiggle the tool until the cover becomes loose.

    • Repeat this on the other side of Controller.

    • Go slow. Take your time removing the handle covers.

  3. TpIDmw2eiQOIMtRP

    • Remove the faceplate.

    • Repeat on the other side of the controller.

  4. clGBJVWDWJCtROTE
    clGBJVWDWJCtROTE
    BJL3TsCHagWnLprm
    qREkvltT4hlV3Pe4

    • Use a Phillips #000 screwdriver to remove four 20 mm screws from the controller's faceplate.

    • Use a Phillips #000 screwdriver (a screwdriver bit extension may be needed) to remove the two 20 mm screws from the controllers faceplate.

    • Screw extender should only be used to unscrew two of the six screws. Do not use for all six.

  5. EJwcjVTJMwjtSkDj

    • Remove the faceplate of the controller by lifting it directly up from the backplate.

    • Be gentle. The controllers backplate is still attached to the faceplate.

  6. wG6PfYBC3M4k1lYY
    wG6PfYBC3M4k1lYY
    jOjeEg2McN6UqVpB
    AfUgnI5Ut2nAjfTS

    • Use a Phillips #000 screwdriver to remove the two 10 mm screws from the daughterboard off the backplate.

    • Remove the daughterboard once screws are off.

    • Be gentle when removing the daughterboard. The daughterboard is still attached to the faceplate.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Melanie Rodriguez

Member since: 18/03/24

385 Reputation

0 comments