Epson PPC650 Camera Case Replacement

Written By: Brittany
  • Comments: 0
Epson PPC650 Camera Case Replacement

Difficulty

Moderate

Steps

5

Time Required

No estimate

Introduction

  1. sBKgBS1Ako3UnvaR
    sBKgBS1Ako3UnvaR
    RTtqQ54VSkZVpd6y
    qSLRXHMMyFE2ugkK

    • Locate the silver power button. Gently slide the button to the middle section labeled "off" to shut down the camera.

    • Remove the batteries from the battery compartment located on the underside of the camera.

    • Remove the SD card from the compartment located on the flat, left side of the camera.

  2. gFYbWLSdqvmPyM3s

    • Remove the two screws on the rounded side of the camera.

  3. Dq4gnvAtCaZY2gNC
    Dq4gnvAtCaZY2gNC
    ttdg3Z4NTkr5TEvH

    • Remove the three screws on the flat side of the camera.

    • All of the silver screws go into the side of the camera that is silver.

    • All of the black screws go into the side of the camera that is black.

  4. JSRC5CO4HZnytnHF

    • Remove the four screws from the bottom of the camera.

    • All of the silver screws go into the side of the camera that is silver.

    • All of the black screws go into the side of the camera that is black.

  5. VNDAVFxoHBY4edT5
    VNDAVFxoHBY4edT5
    6tLX2pehWcLiE2CJ
    UNfEZrv5uNaPj4Me

    • Separate the front and the back pieces of the camera's plastic casing using a spudger.

    • WARNING: When pulling the front plastic casing, be careful of the wires that are connected to the aperture control.

    • Use minimal force so that the plastic casing does not break.

    • When separating the small silver siding, the indicator for the view/off/playback may fall out.

    • The plastic viewing window located on the top of the camera may also become lose and fall out.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Brittany

Member since: 12/02/13

101 Reputation

0 comments