Fugoo Tough XL Speaker Replacement

Written By: Abdul
  • Comments: 1
Fugoo Tough XL Speaker Replacement

Difficulty

Moderate

Steps

7

Time Required

25 minutes

Introduction

This guide will show you how to remove and replace the speakers.

  1. VWHioZmOIxHUWHle

    • Remove the four 3 mm screws located in each corner using a 3 mm Hex screwdriver.

  2. RpoxoGP1waeOqxZN
    RpoxoGP1waeOqxZN
    fbRmYRWcRVAnSfxs

    • Gently pull up and off the outer casing.

    • Do not feel afraid to use a bit of force if necessary.

  3. 1TLwLExD3CYBpGek
    1TLwLExD3CYBpGek
    y33TnmE2uyouij2Q

    • Remove the internal device from the outer casing.

    • Remove the four 12 mm screws on each corner using a T10 Torx screwdriver.

    • Remove the eight 6 mm screws on the top and bottom using a T10 Torx screwdriver.

  4. ZYRdwXjPekbijQqR
    ZYRdwXjPekbijQqR
    wNgyiGaiDKGx2uO6
    VNmC2QiWEOfjUHOP

    • Use your hands to gently remove the side plates.

    • Use an opening tool to pry off the back plate with the Fugoo trademark.

  5. RbvbvoNUphsIZinp

    • Slowly pull the front casing from the back casing. Avoid putting any tension on the connected cables.

    • Separate the two slowly and consistently to avoid damaging the speaker cables.

  6. tZUkvCWvbQiFtDZj
    tZUkvCWvbQiFtDZj
    ePYj1a4I35LCvRWX

    • Carefully untangle the wires that are connected from the speaker to the motherboard.

    • Using a tweezer, pull downwards on the base of each red speaker connector to remove them from the motherboard.

  7. unVgbr4UIaZtdMfE
    unVgbr4UIaZtdMfE
    ceyA2u4QSlttOe3F
    rl1rH5h5GhjlBrn4

    • Use a #3 Hex screwdriver to unscrew all six 3mm screws."

    • While holding the case with one hand, pull up on the speaker you wish to replace.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Abdul

Member since: 17/02/17

527 Reputation

One comment

I need bateray replacement for my fugo xl

Tedy Setyadi -