Gardena BS-XL Spring Replacement

Written By: knipwim
  • Comments: 0
Gardena BS-XL Spring Replacement

Difficulty

Easy

Steps

4

Time Required

15 minutes

Introduction

The Gardena B/S-XL garden shears uses a leaf spring to open the shears when closed. If the spring is broken, you can still use the shears, but it won't open automatically.

This manual will show how to replace this spring when broken.

  1. NpuhilCDpCaaZcCt

    • The bolt holding the 2 blades together is typically fastened with threadlocker from the factory to prevent the bolt from undoing itself when in use.

    • While holding the shears in a vise, undo the T30 bolt holding the 2 blades together.

  2. Jhv1RVECVXIPBEto
    Jhv1RVECVXIPBEto
    ZIHUhOdMiSSbtNLy
    3gAwUDPBssltlM4E

    • This step assumes the spring is broken in the middle.

    • Remove the first part of the broken spring from the handle.

    • Pull the blade from the handle.

    • Remove the second part of the broken spring from the handle. If it is stuck, you can use a flathead screwdriver to wriggle it loose.

  3. DWTURuPJNcLjxVcg
    DWTURuPJNcLjxVcg
    LYZwoeDB3QUliR6f
    DI1Mcvi5DeDNTjMs

    • Slide the new spring into the handle, and make sure there is room for the blade behind it.

    • Slide it in as far as it will go.

    • Push the blade back in until the handle hole aligns with the blade hole. This will put tension on the spring.

  4. nGvNFJgQHhGcHXRp
    nGvNFJgQHhGcHXRp
    s1xKBfPKLKI3ylSC
    tUcMP2bcIQCRmyX3

    • Apply some threadlock on the bolt.

    • Align both blades and insert the nut. Screw in the bolt partially.

    • Ensure the spring is level and pushing against the other blade.

    • Fasten the bolt while opening and closing the shears to make sure it is neither to loose or too tight, and also to verify the spring is working correctly.

Author

knipwim

Member since: 02/09/18

11311 Reputation

0 comments