HP 15-fc0000 Series DC-In Port Replacement

Written By: Spencer Pennington
  • Comments: 0
HP 15-fc0000 Series DC-In Port Replacement

Difficulty

Moderate

Steps

18

Time Required

20 - 30 minutes

Introduction

Use this guide to replace the DC‑in port in your HP 15-fc0000 series laptop. This is the part you plug your charger into.

Note: This procedure was written using a model 15-fc0093dx HP 15 Laptop PC but is compatible with any HP 15 Laptop PC whose model number starts with 15-fc.

This procedure requires removing the battery to disconnect it. Use care to avoid bending, twisting, or puncturing it—a charged lithium-ion battery can be very dangerous if accidentally punctured. If your battery looks puffy or swollen, take extra precautions.

  1. yTLHBPRpQqW2ShcC

    • Shut down the laptop.

    • Unplug the charger and any other cables from the laptop.

  2. UnMHxtysYjMmTCZN

    • Close the laptop and flip it over so the rubber feet are facing up. Place the laptop on a soft surface to avoid damaging the top cover.

    • Use a Phillips screwdriver to remove the four screws securing the bottom cover.

    • Two 6.8 mm‑long screws near the rear of the laptop.

    • Two 4.8 mm‑long screws near the front of the laptop.

  3. OLx62NwqcG2BtuwZ
    OLx62NwqcG2BtuwZ
    jTPC4oZTyHViSBmN

    • The clips attached to the bottom cover are fragile. Use caution when releasing them.

    • Insert an opening pick under the bottom cover at the rear of the laptop.

    • Twist the pick until one or more clips release.

    • Repeat this procedure along the rear edge until you release all the clips.

  4. wguY4oSAl1ii6Eaj
    wguY4oSAl1ii6Eaj
    Y1SJrH1qdKoaRtJy

    • The bottom cover is fragile. Use caution when bending it.

    • Place your fingers under the part of the bottom cover you've raised, near a corner.

    • Use your fingers to gently pry up the corner of the bottom cover.

  5. KjWqRMSf5XC3iyYF
    KjWqRMSf5XC3iyYF
    d46wGsWgGxqWC3rP
    rHDaCZyIgfLW3SPY

    • Insert an opening pick under the edge of the bottom cover next to the corner you've raised.

    • Pry up the back cover clips along the edge.

  6. g42hLGpPvQZfexvq
    g42hLGpPvQZfexvq
    KuwCUsUmHpLlqUVu

    • Use an opening pick to repeat the procedure from the previous step to pry up the remaining sides of the bottom cover.

  7. DBVIiCdyftmaZKOw
    DBVIiCdyftmaZKOw
    QpLYSYRlZiHUsDpA

    • Remove the bottom cover.

    • Some clips may re-engage when you're releasing other sides. If the bottom cover doesn't lift off easily, use the opening pick to release any remaining clips.

    • During reassembly, lay the bottom cover on the laptop so the sides of the cover align with the sides of the laptop. Then, gently press on the sides until you hear the clips click. If the clips don't engage easily, adjust the cover and try again.

  8. dhQgkHgWMcOJBxMt
    dhQgkHgWMcOJBxMt
    YiYWyeYFCFGL3e3s

    • Do not put too much stress on the wire, as that can harm your laptop's audio quality.

    • Use a spudger or your fingers to lift the tape that adheres the speaker wires to the metal trackpad bracket.

    • Try not to fold the tape so it can be reused during reassembly.

  9. LuFkJWDhDwWvCG4E
    LuFkJWDhDwWvCG4E
    hUKIXwpQEfbuTOsn
    AEEYs5p5DOGLrYqF

    • Use a spudger or your fingers to remove the speaker wires from the routing clips along the edge of the battery.

  10. NbDESHH53pXZLNeZ
    NbDESHH53pXZLNeZ
    BfiSfPrIrYMa3aiy

    • Use a Phillips screwdriver to remove the five 4.3 mm‑long screws securing the battery.

    • During reassembly, press firmly on the battery connector to ensure a strong connection.

  11. SmqQMOUQZAi5vgTO
    SmqQMOUQZAi5vgTO
    MUU2KCROlMcUxNQF
    VkDC6dH3ReXspjbB

    • Do not grab the battery at the ends because this battery is flexible. Instead, grab the battery one inch from each end to better support the middle.

    • Use two hands to grip the battery about one inch from each end.

    • Lift the front of the battery (the side closest to you) until the battery is free of its alignment pegs.

    • Pull the battery towards you to release it from its connector.

    • Don't continue to use a damaged battery, as doing so is a potential safety hazard. If in doubt, replace it with a new battery.

    • During reassembly, insert the battery onto its connector at a slight downward angle before pressing it flat to the frame.

  12. nFAlCM5MCaoXEOWM
    nFAlCM5MCaoXEOWM
    WKSBMRi1QJTnKKjA

    • The right hinge is on the left side since the laptop is upside down

    • Use a Phillips screwdriver to remove the three 5.6 mm‑long screws securing the right hinge.

  13. KHoqZkTvwNyEeKDO
    KHoqZkTvwNyEeKDO
    rXEc6ig6NQrhhfPu

    • Lift the left hinge to 90º so it's pointing upward.

  14. IcNP3POUXiCACFIG
    IcNP3POUXiCACFIG
    OjCdqQESGLDHoWMG
    hY3TfailBxq5FrAC

    • Use a spudger to "walk" the DC‑in cable out of its socket on the motherboard by pushing on alternating sides of the white connector.

  15. eK1wCQcJHJxkkhWl
    eK1wCQcJHJxkkhWl
    twHkpl3lNgXxpyAu

    • Once the cable it loose, use a spudger to push the DC‑in cable out of its socket on the system board.

  16. H5NWXLAKMtY3yYMW
    H5NWXLAKMtY3yYMW
    tPywReaavv6RKVU1
    5qZmDXiRYrHsHKaQ

    • Use tweezers, a spudger, or fingers to lift the DC‑in cable out of the routing clips beside the fan.

    • During reassembly, make sure the cable is routed through the proper clips.

  17. iveoplyRWXLXYhlM
    iveoplyRWXLXYhlM
    34UU4v1SiFa4DkUZ

    • Use a Phillips screwdriver to remove the 3.1 mm‑long screw securing the DC‑in port.

  18. eO3NrrITk3HxxHXk
    eO3NrrITk3HxxHXk
    SSJPDsTLSTXhVTgv

    • Use tweezers to pull the DC‑in port away from its slot in the frame to remove it.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Take your e-waste to an R2 or e-Stewards certified recycler. Depending on your region, used HP devices and parts can be returned for reuse or recycling through the HP Planet Partners program.

Repair didn’t go as planned? Try some basic troubleshooting, or ask our Answers community for help.

Author

Spencer Pennington

Member since: 09/09/23

17064 Reputation

0 comments