Head Strap Removal (only for the Head Strap)

Written By: Sam Omiotek
  • Comments: 0
Head Strap Removal (only for the Head Strap)

Difficulty

Moderate

Steps

6

Time Required

No estimate

Introduction

This is a prerequisite-only guide! This guide is part of another procedure and is not meant to be used alone.

  1. mPWInBOiUxUoIWHk
    mPWInBOiUxUoIWHk
    32lhPiKJihIMHrPC
    uLLL1T1UQArB36AA

    • Peel off both front side foam pads to uncover the speaker wires.

  2. t6vDCnMiVLFAL4PR
    t6vDCnMiVLFAL4PR
    slTfqZlYFlIpvRDn
    v3IOaci2GtBbSDqL

    • Use the point of your spudger to pry out the two rubber spacers next to the headphone screws.

    • Be careful not to accidentally pry any of the speaker wires under the rubber spacer.

  3. CVbX4PPWpfuB3Lev
    CVbX4PPWpfuB3Lev
    gTHLVQVxN2kPBLhD

    • Use the point of your spudger to pry up and disconnect both the left and right headphone speaker wires.

  4. is1mqUj1UohMBXoG
    is1mqUj1UohMBXoG
    TTDvBZ5tWGuSPTej

    • Use a T6 Torx screwdriver to remove the two 12.1 mm screws (one on each side) securing the head strap to the headset.

  5. 2KDUshEaMsb6IDTc

    • Remove the two plastic spacers underneath the previously removed Torx T6 screw.

  6. wifnXFGOEgTEfFXd
    wifnXFGOEgTEfFXd
    JCVxpnXqUOImeZhg
    kcUiO6qBPPYHBAdT

    • Thread the headphone speaker wires out through both ends of the head strap.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Sam Omiotek

Member since: 25/02/19

84587 Reputation

0 comments