Introduction
This guide will show you how to replace the brush roll in a Hoover Power Path Deluxe FH50951 vacuum. When following this guide, you will be removing two pieces: one that covers the brush rolls and another that covers the belt next to the wheel. You may need a longer Phillips #1 screwdriver for step 2.
Tools
-
-
Remove the four 18.6 mm screws labeled 1-4 using a Phillips #1 screwdriver.
-
Remove the piece that was being held down by those screws.
-
-
-
Remove the four 18.6 mm screws with arrows listing 5-8 using a Phillips #1 screwdriver.
-
Remove the wheel assembly on the left side of the vacuum.
-
-
-
Lift up the belt to give enough slack to allow the brush roll to come out.
-
While lifting the belt, pull/push upward away from the cleaner to pop it out.
-
To reassemble your device, follow these instructions in reverse order.
