Introduction
This guide shows you how to replace a faulty condenser in your dryer. A worn condenser can prevent the motor from spinning properly, causing cold, damp laundry and risking damage to the heating system. You should always refer to your manufacturer’s guidelines and be aware that any modification can affect your warranty.
Tools
Parts
-
-
Check if the drum is not spinning and the clothes remain cold and wet after a cycle.
-
Listen for a strained motor sound as it tries to turn without enough support.
-
Recognize that a non-spinning drum can trigger a safety cutoff for the heating element.
-
-
-
Take out the condensation tank from the front compartment.
-
Locate and unscrew the two plastic screws in the tank area.
-
-
-
Remove the screws at the rear side of the dryer using a suitable screwdriver.
-
Lift and detach the top panel or cover once the fixing screws are out.
-
Look for additional screws along the edges and remove them carefully.
-
-
-
Gently lift and tilt the rear panel to reveal the internal components.
-
Verify the condenser is located next to the motor assembly.
-
-
-
Loosen the nut or bracket holding the condenser with a wrench or similar tool.
-
Unplug the short wires from the condenser terminals to free it.
-
-
-
Position the replacement condenser in the same location and orientation as the old one.
-
Tighten the mounting bracket or nut by hand until it is firmly held.
-
Reattach all panels and screws in reverse order, ensuring a snug fit.
-
Restore power and briefly run a cycle to confirm normal drum rotation and heating.
-
-
-
Locate the thermal cutout near the heating element if the dryer stopped heating completely.
-
Check if it must be reset by pressing the small button on the cutout to restore normal function.
-
Replacing the condenser restores proper motor rotation and drying performance. Always follow your manufacturer’s instructions and be aware of warranty implications before making any repairs. If you encounter difficulties, consult a qualified service technician.
