Introduction

  1. WhxQfY3dCJJPFOJW
    WhxQfY3dCJJPFOJW
    RHGaWiB3DSTJ2OSy
    • Open the cover and press the SIM card and Micro SD card in to release them both.

    • Remove the screw under the hinge cover.

  2. TEqEneeVkEUYY1Zs
    • Use a prying tool to loosen the back cover from the display.

    • There are plastic clips holding the display and back cover together, but they come apart quite easily.

  3. WjVY1CxjZ63ZTOjE
    • Carefully separate the display unit from the back cover, but not too far.

    • There is a cable connecting the two together.

    • Lift the ZIF Connector and remove the Display Cable.

    • Lay the display to one side.

  4. lBYlBLGoXfdx5dOX
    lBYlBLGoXfdx5dOX
    YmNLG6DMD61lOZQJ
    • Flip the ZIF connector to loosen the flex cable for the USB charger port.

    • It is possible the cable is glued down, sliding a flat tip underneath should be enough to loosen it for removal.

    • Remove the two screws holding the charger port in place.

  5. bCrWgc6p5ytIeZXc
    bCrWgc6p5ytIeZXc
    GC4QG1HJZj6vnxVq
    • Install the new charger port, Insert the cable in the ZIF connector and test to make sure it charges. Replace the screws for the USB Board

    • Insert the display into the back cover.

    • Replace the screw by the SIM card / Micro SD card slot.

    • Completed!

Conclusion

To reassemble your device, follow these instructions in reverse order.

Harvey

Member since: 15/02/16

5820 Reputation

3 comments

Is this charger available

Doyin Nwakanma -

Charger port for Huawei s10

Doyin Nwakanma -

My s10 is not charging,if i plug it will show as if it was going to charge but it won't so what do i do in this situation

Doyin Nwakanma -