Introduction

To complete this guide, you will need to purchase a new LCD cover and make sure that you have the tools listed. It is always good practice to make sure that the device is completely powered off and remove the battery before attempting any repairs.

  1. 4shyQt5amun1eDKJ
    • Find the side of the camera with the black switch shown.

  2. B2Ja4KpkSs213ws4
    • Push down on the black switch.

  3. UuBMOoDQ5IxWHGIb
    • Slide the battery cover back while pushing down on the black switch.

  4. G2BFqCBcMlljvPYA
    G2BFqCBcMlljvPYA
    MQiOEgZhZbvEMgkx
    • Open the battery compartment and push the blue battery release switch.

  5. XlJHBBAkLQ4jSR4x
    • Remove the battery from the camera.

  6. oDbfFbEEE252AewQ
    • Remove the two Phillips screws (4mm x 3mm) using the Phillips #00 screwdriver.

  7. Yfy2QoqCVJMpRpIV
    Yfy2QoqCVJMpRpIV
    kVwDLeuE1PmrPtx2
    • Remove the 8 screws (5mm x 4mm) from the corners of both the front and back of the camera (4 screws on each side) using the T6 Torx screwdriver.

  8. tigebEgbvvlHbxMi
    • Carefully open the camera as shown and gently peel off the black cover tape.

  9. GZCaCBhFhBgRXNu4
    GZCaCBhFhBgRXNu4
    IJlv2skKDewADkal
    sTYM2WNTKfEEsDOQ
    • Carefully lift up and remove the cable ribbon clip using the tweezers.

  10. 4jIwC6jRLGfUD6on
    4jIwC6jRLGfUD6on
    KLpk2sRIvjlR12EZ
    • Carefully grasp and remove the ribbon cable using the tweezers.

  11. DCO1vgcRJwgreXEW
    • Turn the camera as shown and carefully remove the glue from the connector.

  12. WFoPKxSRX6pE5nNX
    WFoPKxSRX6pE5nNX
    w5oj5QhQIcjd5uHS
    • Carefully pull the white clip out of the casing using the tweezers.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Christina Michelle Johnson

Member since: 16/01/15

1047 Reputation

0 comments