KYVOL CYBOVAC E20 Main Brush Replacement

Written By: Hailee Ledgerwood
  • Comments: 1
KYVOL CYBOVAC E20 Main Brush Replacement

Difficulty

Very easy

Steps

4

Time Required

1 minute

Introduction

The Kyvol Cybovac E20 has a main rolling brush that may stop functioning over time from use. The brush should be taken out and cleaned, but if this does not work, the brush may be broken. If your vacuum is not cleaning well, use this guide to replace a broken main brush.

  1. yTfsry5YoEShrDd4

    • Turn vacuum off and lay on flat surface.

  2. b6FUVvf2xneE2Qlw
    b6FUVvf2xneE2Qlw
    WCkEuXhbXMtaEkQP

    • Turn vacuum over and identify the main brush compartment.

  3. Z2SoWFsQy1LXIYPD

    • Take off the orange cover guarding the brush

  4. V11yQnTpDbVCcPHT

    • Remove the main brush from the vacuum by pulling it out.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Hailee Ledgerwood

Member since: 09/02/23

109 Reputation

One comment

I did everything cleaned and replaced with new parts and still not spinning

Robomom -