KitchenAid Professional 600 Gear Housing Cover Replacement

Written By: Luke
  • Comments: 2
KitchenAid Professional 600 Gear Housing Cover Replacement

Difficulty

Easy

Steps

5

Time Required

No estimate

Introduction

  1. fbmOcR1Nv425QUqh

    • Take out the screw which holds on the silver band using a Phillips #2 screwdriver.

    • Remove the silver band.

    Maybe start with unplugging it ?

    Ryan F -

  2. ZCMIIPP1eoaPPXvx

    • Remove the four Phillips #2 screws located around the mixer where the band was removed.

    • This picture only shows two of the screw that you need to remove. The other two are on the exact opposite side of the mixer.

  3. HrJKZjfMarTMmBHX

    • Remove the top of the mixer to reveal the inner parts.

    • The top should lift off, but may not if it is stuck. A sharp strike from the back with the hand may unstick it. It will slide forward about a 3/8 of an inch. Push it back again from the front and it should be free enough to lift.

  4. IQCiZubTKxHaFwmc

    • Remove the 4 Phillips #2 screws connecting the black housing cover to the device.

    • Only one of the screws is seen in the picture. The other three are also located around the black housing cover.

  5. wUIy4YqJOc6II1dj

    • Take off the black housing cover.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Luke

Member since: 11/04/16

1380 Reputation

One comment

I find your instructions very helpful but one of my housing pins have broken off, Can it be replaced or do I need to replace the housing? If so where do I find the housing part. I can not find it.

w.gupton -