Introduction

This guide demonstrates how to replace the speakers of your Lenovo Ideapad 320-17IKB. The speakers are responsible for the output of external audio from the system. Whether your laptop is suffering from fuzzy sound, low volume, or just simply malfunctioning, use this guide to conduct a complete replacement of both speakers.

Before you begin this repair, turn off your laptop and unplug it from the charger.

  1. qPd2DtrQgRKQKb1t
    • Turn off and unplug the computer.

    • Flip the laptop over so that the back panel is facing upwards.

  2. 3TCtqgvmXOsIcHPa
    3TCtqgvmXOsIcHPa
    Dn3la3RNcWOwssoE
    • Remove fourteen 7mm Phillips #00 screws from the back panel.

    Philips 0 or Philips 1 works better.

    Thorbjørn Kühl -

  3. cETjVT2ijDGZjOnR
    • Carefully remove the optical drive by pulling the bezel away from the laptop.

  4. FarGMLbgqCstKtah
    FarGMLbgqCstKtah
    O1X1ANpWQbmUOr25
    • Use your fingers or an opening tool to gently remove the back panel from the bottom of the laptop.

    • Lay both sides of the laptop next to each other.

  5. Gncn2rB4H3IAOp3J
    Gncn2rB4H3IAOp3J
    WNAVPm1UOoGw5mVw
    • Remove five 7mm Phillips #0 screws from the battery holder.

  6. ox5ekt26Dux4BYHm
    ox5ekt26Dux4BYHm
    1NfNYE2ZfrvTyJr6
    • Pinch the connecting cord with one hand and pry the battery connector with the other hand, while gently pulling the connector straight out and towards the bottom edge of the base.

    • When removing the battery, use care to keep it flat and do not open the battery because it can result in fire or explosion.

  7. fhFw13vU1s1oPHqm
    fhFw13vU1s1oPHqm
    sWtCK1NFsDbRXjaE
    • Gently pinch the white tab and pull the speaker cable out of its socket.

    • Don't pull on the cables.

    • The speaker connector is located directly underneath the battery.

    • If you can't get the speaker cable out by hand, use the point of a spudger to push on alternating sides of the connector to "walk" it out of its socket.

    • It may take a lot of alternating before the connector comes out.

    • To reconnect the cable, align the connector and use a spudger or clean fingernail to push it fully into the socket.

    • Don't push on the cables themselves, or you may damage the connector.

  8. 1vABqDvhIDHESdds
    1vABqDvhIDHESdds
    2oZmIjnu1s5lDtbC
    gJenUXUtmuYfquDq
    • Lift the left and right speakers up and disconnect the cables from the chassis to remove the speaker assembly from the laptop.

Conclusion

To reassemble your device, follow these instructions in reverse order. Take your e-waste to an R2 or e-Stewards certified recycler.

Amy Aquije

Member since: 08/02/24

85 Reputation

0 comments