Introduction

If the Lenovo ThinkPad Yoga 11e Gen 6 is having trouble connecting or staying connected to the Wi-Fi network, the Wi-Fi board may need to be replaced. The Wi-Fi board allows the device to connect to wireless networks. This guide will demonstrate the process of replacing this component.

  1. Z4LO3VPC6eCSnanL
    • Wearing the anti-static wrist strap will prevent a static shock from damaging the components in the laptop.

    • Disconnect the laptop from power and make sure it is completely powered off.

    • Turn the laptop facing down.

    • Loosen the eight captive screws using a JIS #0 screwdriver.

    • The screws are attached to the panel and cannot be removed.

    • Use a spudger to release the tabs securing the back case and carefully remove the panel.

  2. T46xOMcPoq1MsQsn
    T46xOMcPoq1MsQsn
    eW1KmSp4MMGBAMad
    • Remove the three 4.5 mm screws from the battery using a JIS #0 screwdriver.

    • Lift the battery, then use your fingernail to slide the connector out of its socket.

    • Remove the battery.

  3. La6rwrlvgS326hYT
    La6rwrlvgS326hYT
    cuFwgNUduCvLqDtA
    • Push on alternating sides of the JST connector and pull straight away from the socket to disconnect the CMOS battery.

  4. OTFL6334wWygPFqr
    OTFL6334wWygPFqr
    KO2iHCqpLOZgI26f
    uchb3CtLVLJpwOQi
    • Lift the two wires and plastic piece away from the Wi-Fi board.

    • Remove the single 3 mm screw holding the Wi-Fi board in place using a Phillips #0 screwdriver.

    • Hold the sides of the Wi-Fi board and slide it out of the socket.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Lex

Member since: 02/10/24

509 Reputation

0 comments