Marshall Stanmore II Tweeter Assembly Replacement

Written By: Jacob Rose Parks
  • Comments: 1
Marshall Stanmore II Tweeter Assembly Replacement

Difficulty

Moderate

Steps

7

Time Required

30 minutes

Introduction

This guide is to be used for the replacement of one or both tweeter assemblies in the Marshall Stanmore II Bluetooth Speaker.

The tweeters produce high-frequency sounds in a speaker. These high-frequency sounds allow listeners to hear the treble in music. If a speaker has a malfunctioning tweeter, anything played would sound muddy and incomprehensible.

Before using this guide, make any adjustments for the treble and bass using the dials on top of the speaker or through the Marshall Bluetooth app. After adjustment, verify if the sound quality has improved. If there is no improvement, follow the troubleshooting steps on the Marshall Stanmore II Bluetooth Speaker Troubleshooting page before attempting to disassemble.

  1. AKWIA1nG1XUe6bJy
    AKWIA1nG1XUe6bJy
    12XgYFFMsALdh2P4

    • Turn off the device and unplug the cable from the wall and the speaker.

    • Lay the speaker with the back panel facing up on a flat, stable work surface.

  2. K1pqyIQbohWadoMI
    K1pqyIQbohWadoMI
    2prEn3HXlrJ6Ry2v

    • Use a Phillips #2 screwdriver to remove the ten 20.5 mm screws that secure the rear panel to the chassis.

  3. vGAAAkbQexnlE2Ab
    vGAAAkbQexnlE2Ab
    IfC1CIotronJCclW

    • Carefully lift the rear panel and let it rest on an object, like a stack of books, to avoid straining the cables.

    • Do not attempt to fully remove the panel, as this will damage the connections inside.

  4. nuL2CvxFDmOYmAb4
    nuL2CvxFDmOYmAb4
    IvxZrUffQ2PyDrc1

    • Carefully pull back the translucent plastic sheathing on the two silver tweeter connectors.

  5. ZGX6Ey4DtLeTiNgD
    ZGX6Ey4DtLeTiNgD
    hICevpjrVAqmrHaj
    RxetclqdclgTKnLI

    • Using your fingernail or tweezers, apply precise pressure to the small latch in the middle of the connector and gently pull upwards to disconnect the connector.

    • Repeat for the second connector.

  6. qkQ4pxKVWbBqUivv
    qkQ4pxKVWbBqUivv
    mFsuNOaJPCrdDVLO

    • Use a Torx T20 screwdriver to remove the three 20.5 mm screws that secure the tweeter.

    • Lift the tweeter assembly from its housing.

  7. 4sqPiujdgEZJADOH

    • The felt seal is removable. If there is no seal on the tweeter, it may be stuck to the cutout on the speaker frame.

    • Repeat steps 4-6 to remove the second tweeter if necessary.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Jacob Rose Parks

Member since: 07/02/24

491 Reputation

One comment

Do you know the tweeter spec? Or similar brand to install?

Leonardo Hernández -