Motorola Moto G Stylus 4G (2023) Charging Port Replacement

Written By: Camille Holley
  • Comments: 0
Motorola Moto G Stylus 4G (2023) Charging Port Replacement

Difficulty

Moderate

Steps

12

Time Required

20 minutes

Introduction

Full Device Name: Motorola Moto Stylus 4G (2023)

Model Number: XT2317-2

Alternate Name: Moto Stylus 4G (2023)

Objective: This guide aims to provide step-by-step instructions for replacing the charging port in the Motorola Moto Stylus 4G (2023).

About the Charging Port: This device sports a Type-C USB dock connector charging port.

Device Symptoms: If the phone is not charging consistently or at all, refer to this guide to replace the charging port.

  1. wGjrLQWONZNuQRdN
    wGjrLQWONZNuQRdN
    hJqTpUrkD5LRMrIV

    • Insert an opening pick under the edge of the case and slide it around the edges.

    • Separate the back panel from the rest of the phone.

  2. 5AGtKRrh2ufqJcrT

    • Remove the seven 4 mm screws from the phone’s top with a Torx T5 screwdriver.

  3. CHsNKlxDLZvaZ4ri
    CHsNKlxDLZvaZ4ri
    WRSLKVRUbekaCMpW

    • Use the opening pick along the edges to separate the camera lens glass from the board.

  4. se5OKYxII61smP5C

    • Remove three 4 mm screws with a Torx T5 screwdriver.

  5. yNxbuAfPL36VNhS3

    • Pry off the top perimeter with an ESD-safe spudger and set it aside.

  6. CWgIdYJMs2RnEcAu
    CWgIdYJMs2RnEcAu
    VqjKuydEapBJhJBT

    • Pull the black tab off of the battery gently with your hand.

  7. hCb4TPyHNVhZRZcH
    hCb4TPyHNVhZRZcH
    cu5ngxQTgRFkHgq6

    • Disconnect the four cables by inserting the opening pick beneath the edge of each.

  8. Ji6BKN2TR3kSOGDK
    Ji6BKN2TR3kSOGDK
    4AfwLCHmGNqvkW5X

    • Together with the opening pick and an ESD-safe spudger, remove the old battery.

  9. ZaeTrhMkQ3XDk5XF

    • Remove seven 4 mm screws with the T5 Torx screwdriver.

  10. jFfyxFwbJF5mXWt5
    jFfyxFwbJF5mXWt5
    HMURHFFStURQUlDj

    • Remove the speaker using an ESD-safe spudger.

  11. HStEhVeYDlegRC2L

    • Unplug the two antenna heads and main ribbon connector cable from the charging port board.

  12. qlnp1LWe5GA4dh66

    • Pull the faulty charging port from the device body.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Camille Holley

Member since: 14/02/24

585 Reputation

0 comments