Motorola Moto G3 Motherboard Replacement

Written By: Irkan Notta
  • Comments: 2
Motorola Moto G3 Motherboard Replacement

Difficulty

Moderate

Steps

6

Time Required

10 - 15 minutes

Introduction

Click here for an updated version of this guide. The version you are viewing is retained for historical purposes.

In this guide we will be removing and replacing the motherboard, which is the main source for all the other guides.

  1. NVF2KG4CWaWDkAQA
    NVF2KG4CWaWDkAQA
    giumjZDhP1jyJeTh

    • Use the plastic opening tool to open the back cover as shown in the photo.

  2. voBV3buX2wrcKNML

    • Heat an iOpener in the microwave for 30 seconds.

    • Place the heated iOpener on all four edges of the screen for approximately 2 minutes.

  3. RFAnyg3gWCyIASgW

    • Apply the plastic opening tool on the edge of the screen near the front camera.

    • After creating enough space, allow the opening tool to be inserted on the side of the phone.

    • Create another space on the other side of the screen.

    • Leave the opening tool inserted.

    • Carefully apply the larger plastic opening tool by sliding it through the longer edge of the screen.

  4. WPrLPBISPcnWSDZl
    WPrLPBISPcnWSDZl
    bT3ughb3WOPet3HB
    cH6wL5RELvfCU2Wd

    • A strip will be attached to the motherboard as shown.

    • Using tweezers, carefully detach the strip from the motherboard.

    That strip is the LCD display assembly flex cable, and it is attached to the motherboard via a ZIF connector. Using tweezers or a spudger, the plastic latch (which is on the side nearest the edge of the phone) must be gently lifted up away from the phone’s edge. Only then can the flex cable be safely (and carefully) removed.

    If the repairer attempts to pull the flex cable out of its connector without first opening the latch, either the latch or the flex cable itself is likely to break, greatly complicating the repair.

    Bonnie Baxter -

  5. irDD2leDCLZpcR6H
    irDD2leDCLZpcR6H
    YtLQa53ekDVaMw3r
    KRBLlLYLuU6X3xAs

    • With a T4 screwdriver, remove the10 "yellow" 2mm screws and 4 "black" 2mm screws.

  6. WZTtm6YSbrMGfuuT
    WZTtm6YSbrMGfuuT
    eRNJEUIq5SoJsJho

    • Use the metal spudger and lift the back cover on the bottom side of the phone (this is attached to the motherboard).

    • Remove the motherboard from the device.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Irkan Notta

Member since: 19/03/18

1034 Reputation

One comment

i broke my battery connectig port where we plug in the battery. What should i do?

PLZ answer

All you need to Know (SAMMY) -