Mr. Coffee BVMC-PC05BL2-NP Disassembly

Written By: Ellie B
  • Comments: 0
Mr. Coffee BVMC-PC05BL2-NP Disassembly

Difficulty

Moderate

Steps

7

Time Required

30 - 40 minutes

Introduction

These are the steps to fully disassemble the Mr. Coffee BVMC-PC05BL2-NP (Mr. Coffee 5-Cup Programable Coffeemaker), which will allow you to access components that may need repair. This device was not made to be easy to disassemble, and some plastic components must be removed by force and cannot be removed without damage. Be sure to unplug the coffeemaker before beginning.

  1. k26qvTnuKgh6emPy

    • Begin with your Mr. Coffee machine on a flat surface.

    • Orient your coffee maker upside down.

  2. jGR4nacM2TlIAUCC

    • Remove the three 15 mm screws from the bottom of the machine using a Y1 Tri-point screwdriver.

  3. pKBbIcKbWkqVayRB

    • Remove the two 15 mm screws from the metal bar using a Phillips #1 screwdriver.

    • Remove the metal bar.

    • Remove the two screws holding the cord.

    • Remove the plastic clip that held the cord.

  4. vd6ybTJTJFnHcyVM

    • Remove the black shell on the left by unclipping its clips to reveal the LCD circuit board.

  5. hnRCuupdW3MbRKHG

    • Gently pry out the circuit board.

    • The circuit board is particularly fragile, so be very careful while removing it.

  6. MvNFsHElXxqfeky1

    • Put on eye protection.

    • Break the outer shell to access the electronic components.

    • Plastic edges can be sharp. Make sure to be cautious to avoid injuring yourself.

  7. EQSyEgIjQAPKQRLZ

    • Remove electronic components in one part.

    • In this coffee machine, you begin by filling the water reservoir. Next, you insert a paper filter filled with coffee grounds into the brew basket.

    • The user selects whether they would like to “Brew Now” or “Brew Later.” If they choose to “Brew Now”, the heating metal at the base of the machine begins to heat up. This both warms the plate that the carafe sits upon, and heats the water that drain down from the reservoir and passes through the heater.

    • Once the water is hot enough, the boiling water begins to rise through the second tube into the head that begins showering extremely hot water over the coffee grounds, dripping coffee into the carafe.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Ellie B

Member since: 10/09/24

195 Reputation

0 comments