NexiGo NS32 Battery Replacement

Written By: Matthew Nguyen
  • Comments: 2
NexiGo NS32 Battery Replacement

Difficulty

Moderate

Steps

5

Time Required

5 - 10 minutes

Introduction

This is a guide on how to replace the battery from inside the NexiGo NS32. There are 5 specific steps in this guide that describe how to take the battery out of the controller. Be careful not to damage any of the internal components.

  1. 6vrwWBMKi2tEbUdZ

    • Orient the controller so that it is face down.

  2. BxwnnVkJVcyAvJVm
    BxwnnVkJVcyAvJVm
    MCypkOT2tNO3sg2Q

    • Remove the eight 9 mm Phillips screws that secure the rear case.

  3. qAvLOi5hM6GiBVZa

    • Lift the rear case up and off.

    • You may need to use an opening tool to help release the rear case, but avoid using excessive force so you don't damage the controller.

  4. FiCSFLIVyNdSEiAE
    FiCSFLIVyNdSEiAE
    Hp5mcAYhUDStDKLn

    • Grip the white battery connector and pull it directly out of its motherboard socket.

    • This may require some force, as the connectors are secured with a bit of adhesive. If you're having trouble with disconnection, apply some high-concentration isopropyl alcohol to the adhesive to loosen it.

    • Do not pull on the wires.

    How should I disconnect it?

    Alex Watkins -

  5. VgxbgRKjs1kS3Lfd
    VgxbgRKjs1kS3Lfd
    jNCSbYKwuT4uYTMJ
    5gZyK2atFyQo6B34

    • Lift the battery up and out.

    • Take care not to bend or puncture the battery as you remove it.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Matthew Nguyen

Member since: 29/01/24

235 Reputation

One comment

Do you know what model battery I would need to buy to replace the original?

Jack Dunne -