Ninja Foodi SP101 Control Panel Replacement

Written By: Griffin Peterson
  • Comments: 1
Ninja Foodi SP101 Control Panel Replacement

Difficulty

Difficult

Steps

11

Time Required

15 minutes

Introduction

The control panel on your Ninja Foodi SP101 is the only way to interact with the oven. It is responsible for controlling the temperature, the mode, and the remaining time to cook. A non-functioning control panel prevents the user from interacting with the device.

  1. UxblIxJeMQe3ypv1
    UxblIxJeMQe3ypv1
    Zf3TFjTmJtK3lLDy

    • Use a TR10 screwdriver to remove the four 11mm screws holding the black lever bar in place.

  2. IwYS5sBJgP3SMLR1

    • Remove the black lever bar.

  3. ofy1pbhhVRNHqS6i

    • Use a Phillips #1 screwdriver to remove the three 8mm screws on each side of the back panel.

  4. 6wNQesiRa2kTQ3J4
    6wNQesiRa2kTQ3J4
    r3CJCX1yDa13W6dD

    • Flip the device upside down and open the bottom panel.

    • Remove the 3 x philips #1 screws along the top edge of the interior using a screwdriver. The Bottom 2 do not have to be removed.

  5. frPxJEWA6pBYuSXG
    frPxJEWA6pBYuSXG
    1gEXfH3lct1wOcWL
    iUR2DB4ecmbJXiVj

    • Remove the control side panel. To remove it, push forward towards then front control panel to release the tabs out of the main body. Fold away the side panel when the tabs have visually released from their slots in the main body.

  6. PwWbluNUFQLQLdOK
    PwWbluNUFQLQLdOK
    spOUbMnrwmmQPoph

    • Lift the handle and pull the side panel out.

    • Remove the handle side panel.

    There's a Torx screw inside the oven you need to remove as well...

    Richard Klingler -

  7. KaTBSUy2KqRvhmAY

    • Remove the 10mm screw using the Phillips #1 screwdriver.

    • This screw connects the motherboard to the motor.

  8. pjaTHOWVk2taJBgE
    pjaTHOWVk2taJBgE
    QPAsMLSdmdLDIKmP
    MUAY1t5KJOH6IWuC

    • Locate the control panel.

    • Slide the top panel outwards and to the right.

  9. 5iL3qlZQUce6rqOU

    • Remove the three 8 mm screws with the Phillips #1 screwdriver.

    • These are located on the control panel side that was facing inward.

  10. GSPjiuw6KmF1XORq
    GSPjiuw6KmF1XORq
    gPtSOuxhGwu6SUf4

    • Unclip the wires from the motherboard.

  11. MEffn5yqO2kjvTDG

    • Remove the control panel.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Griffin Peterson

Member since: 30/01/24

592 Reputation

0 comments