Ninja Foodi SP101 Temperature Sensor Replacement

Written By: Griffin Peterson
  • Comments: 4
Ninja Foodi SP101 Temperature Sensor Replacement

Difficulty

Difficult

Steps

7

Time Required

15 minutes

Introduction

Reaching the desired temperature on your Ninja Foodi SP101 is an essential feature. The temperature sensor inside the device regulates temperature and the cooling fan. The inability to reach high temperatures on your Foodi may be due to a malfunctioning temperature sensor.

.

  1. UxblIxJeMQe3ypv1
    UxblIxJeMQe3ypv1
    Zf3TFjTmJtK3lLDy

    • Use a TR10 screwdriver to remove the four 11mm screws holding the black lever bar in place.

  2. IwYS5sBJgP3SMLR1

    • Remove the black lever bar.

  3. ofy1pbhhVRNHqS6i

    • Use a Phillips #1 screwdriver to remove the three 8mm screws on each side of the back panel.

  4. 6wNQesiRa2kTQ3J4
    6wNQesiRa2kTQ3J4
    r3CJCX1yDa13W6dD

    • Flip the device upside down and open the bottom panel.

    • Remove the 3 x philips #1 screws along the top edge of the interior using a screwdriver. The Bottom 2 do not have to be removed.

  5. frPxJEWA6pBYuSXG
    frPxJEWA6pBYuSXG
    1gEXfH3lct1wOcWL
    iUR2DB4ecmbJXiVj

    • Remove the control side panel. To remove it, push forward towards then front control panel to release the tabs out of the main body. Fold away the side panel when the tabs have visually released from their slots in the main body.

  6. PwWbluNUFQLQLdOK
    PwWbluNUFQLQLdOK
    spOUbMnrwmmQPoph

    • Lift the handle and pull the side panel out.

    • Remove the handle side panel.

    There's a Torx screw inside the oven you need to remove as well...

    Richard Klingler -

  7. BOcb2iEnmDPTZynT
    BOcb2iEnmDPTZynT
    QuBYt2nQLh2Qn25D

    • The temperature sensor is found under the handle side panel.

    • The sensor is held down by a rivet. Here is a guide to removing rivets.

    It would be great to know how to replace the sensor at this point. I managed to make it this far on my own, but I'm unsure how to remove the sensor itself from the small metal plate it's clamped into.

    Andrew Jensen -

    Where do you purchase a new temp sensor?


    Charles Carlin -

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Griffin Peterson

Member since: 30/01/24

592 Reputation

One comment

Where do you purchase a new temp sensor?

Charles Carlin -