ORFELD EV-660-S222 Battery LED Board Replacement

Written By: Sarthak Shrestha
  • Comments: 0
ORFELD EV-660-S222 Battery LED Board Replacement

Difficulty

Difficult

Steps

7

Time Required

45 minutes - 1 hour

Introduction

If the LEDs for the battery life indicator on your ORFELD EV-660 have gone out, it can make it impossible to tell how much charge you have left and how long you can continue to vacuum for. Make sure to exercise caution when desoldering wires.

  1. 2KVZPYloccH5yoKW

    • Separate the dust cover and the motor from the vacuum body by pressing the eject button.

  2. fl1mIBwuPtKofYIu
    fl1mIBwuPtKofYIu
    ZSOGVkqlnytDpJJR

    • Place the vacuum on its side, with the screws facing towards you.

    • Remove the 11.5 mm screws using a Phillips #1 screwdriver.

  3. t2C26JUYqDmtaepl
    t2C26JUYqDmtaepl
    atuAggFNYIbKCFko

    • Using tweezers, remove the sticker connecting the two halves.

    • Use the opening pick to gently separate the top half and the bottom half of the vacuum.

    • Press the blue buttons near the sides of the battery LEDs to remove the top half.

  4. ZECft2bo54ISrlbE
    ZECft2bo54ISrlbE
    bnbFwhp3URwI4kES

    • Slide out the charging port.

  5. BWTiPCrVDaVfXgXl

    • Lift the battery slightly to reveal the pin connectors.

    • Gently disconnect the six-pin connector that connects to the power button and battery LEDs.

  6. 6YEoEQwTmpLp3VOl
    6YEoEQwTmpLp3VOl
    OKLXZGLPgDE1LJBF
    MMlMFympJXuIhTe6

    • Slide out the battery LEDs from the compartment.

    • Remove the plastic LED cover from the LED board.

  7. QGWPRBdaWAIDr4xh

    • Desolder the LED board from the wires.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Sarthak Shrestha

Member since: 12/09/23

462 Reputation

0 comments