ORFELD EV-660-S222 Charging Port Replacement

Written By: Sarthak Shrestha
  • Comments: 2
ORFELD EV-660-S222 Charging Port Replacement

Difficulty

Moderate

Steps

5

Time Required

45 minutes

Introduction

If your ORFELD EV-660 has stopped charging entirely or rapidly starts and stops charging, your charging port is most likely the culprit.

  1. 4YlMEivVGimINBxm

    • Separate the dust cover and the motor from the vacuum body by pressing the eject button.

  2. SEXp4cSbJZYE11OA
    SEXp4cSbJZYE11OA
    WYXOYlx1xJUPaLrM

    • Place the vacuum on its side, with the screws facing towards you.

    • Remove the 11.5 mm screws using a Phillips #1 screwdriver.

  3. odrYTGtZyymcDaum
    odrYTGtZyymcDaum
    INaoAAUSvgXknyJT

    • Using tweezers, remove the sticker connecting the two halves.

    • Use the opening pick to gently separate the top half and the bottom half of the vacuum.

    • Press the blue buttons near the sides of the battery LEDs to remove the top half.

  4. byuQrBi4Qk6wIKxw
    byuQrBi4Qk6wIKxw
    oQsU2PQe5iVNSOdF

    • Slide out the charging port.

  5. ma1CHExj6rrClNKJ
    ma1CHExj6rrClNKJ
    bhPAnlKkjIlDKoiP
    cHTbcpdg1ciDXSJH

    • Lift the battery slightly to reveal the pin connectors.

    • Gently remove the four-pin connector connecting the charging port.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Sarthak Shrestha

Member since: 12/09/23

462 Reputation

2 comments

I need the diagram how to replace battery the wiring diagram please

Bennie -

I need the diagram of a battery pack on a bennett read ev-S

Bennie -