ORFELD EV-660-S222 Power Button Spring Replacement

Written By: Emma Lucas
  • Comments: 0
ORFELD EV-660-S222 Power Button Spring Replacement

Difficulty

Moderate

Steps

5

Time Required

45 minutes

Introduction

The spring inside your ORFELD EV-660’s power button may need to be replaced if pushing the power button fails to turn on the vacuum or causes the button to get stuck. This guide will show you how to replace the power button’s old spring.

This guide requires you to disassemble your vacuum. Work in a clear area to avoid losing detached parts.

  1. gZYwImWBdfLRcfNV

    • Separate the dust cover and the motor from the vacuum body by pressing the eject button.

  2. UtSNDOCkbatEon5B
    UtSNDOCkbatEon5B
    BlReehdagOcBDdBf

    • Place the vacuum on its side, with the screws facing towards you.

    • Remove the 11.5 mm screws using a Phillips #1 screwdriver.

  3. YvPpPeDpKJKwECvL
    YvPpPeDpKJKwECvL
    6PCoOBWUNWKLGDyF

    • Using tweezers, remove the sticker connecting the two halves.

    • Use the opening pick to gently separate the top half and the bottom half of the vacuum.

    • Press the blue buttons near the sides of the battery LEDs to remove the top half.

  4. UhmOHNMkjQwUGv4i

    • Lift the battery slightly to reveal the pin connectors.

    • Gently disconnect the six-pin connector from the battery.

  5. ZkPxNlENTFePjJra
    ZkPxNlENTFePjJra
    TEY2FQEysCBhcywZ
    ulSW4l2TeBYvNIoG

    • Gently pull out the power button from the board.

    • Gently pull up and twist the old spring off of the button.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Emma Lucas

Member since: 27/09/22

241 Reputation

0 comments