Omaker M4 Back Case Replacement

Written By: [deleted]
  • Comments: 0
Omaker M4 Back Case Replacement

Difficulty

Easy

Steps

5

Time Required

No estimate

Introduction

Removing the back case from the speaker is relatively easy. Once you unscrew the four back screws, there is a wire that is attached to the back case. Before pulling the back case completely off, disconnect the wire from the back case by carefully pulling it out with tweezers. This will allow the back case to be completely removed from the device.

  1. hiZccfgrEhqdwQsy

    • Flip the device over so the front of the speaker is facing down. Make sure to place the speaker on a flat surface

  2. IUAlASlbahCRoOYu
    IUAlASlbahCRoOYu
    AN3RvTflmTNfckVY

    • Use a T6 Torx screwdriver to remove the four 9mm screws from the back of the device.

  3. YglOmUGVXVbUO3Cr
    YglOmUGVXVbUO3Cr
    KgqAAAOPswRqQpvb

    • Use a magnet to remove the screws after unscrewing them and place them aside.

  4. eBx2BVm1GcGCvOb6

    • Carefully remove the back cover without breaking the battery wire.

  5. HOMC1Bpqd3dEtk6X
    HOMC1Bpqd3dEtk6X
    RRMjmikwIFaKJPwa

    • Remove the end of the battery connection from the motherboard by holding the end of the wire and carefully pulling it out of the socket using tweezers.

    • The battery is still attached to the back cover.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

[deleted]

Member since: 17/02/16

679 Reputation

0 comments