Omaker M4 Motherboard Replacement

Written By: [deleted]
  • Comments: 0
Omaker M4 Motherboard Replacement

Difficulty

Moderate

Steps

10

Time Required

10 - 15 minutes

Introduction

Removing the motherboard from the device is fairly simple. However, be careful not to remove the motherboard without removing the three screws and the wires from the speaker and microphone.

  1. hiZccfgrEhqdwQsy

    • Flip the device over so the front of the speaker is facing down. Make sure to place the speaker on a flat surface

  2. IUAlASlbahCRoOYu
    IUAlASlbahCRoOYu
    AN3RvTflmTNfckVY

    • Use a T6 Torx screwdriver to remove the four 9mm screws from the back of the device.

  3. YglOmUGVXVbUO3Cr
    YglOmUGVXVbUO3Cr
    KgqAAAOPswRqQpvb

    • Use a magnet to remove the screws after unscrewing them and place them aside.

  4. eBx2BVm1GcGCvOb6

    • Carefully remove the back cover without breaking the battery wire.

  5. HOMC1Bpqd3dEtk6X
    HOMC1Bpqd3dEtk6X
    RRMjmikwIFaKJPwa

    • Remove the end of the battery connection from the motherboard by holding the end of the wire and carefully pulling it out of the socket using tweezers.

    • The battery is still attached to the back cover.

  6. RfE26VxHsRqsaItF
    RfE26VxHsRqsaItF
    my3LqNdyEsOOjmrt

    • Remove the mic wire by carefully pulling the plug out of the socket.

  7. RbtqCVsjQDuF3kIb

    • Remove the speaker wire by carefully pulling the plug out of the socket on the motherboard.

  8. XVD23bBFCECKZo2B
    XVD23bBFCECKZo2B
    pIHdXtKt5AJiEToO

    • Use Phillips PH00 screwdriver to remove the three screws holding the motherboard in place.

  9. xsQpuQcIFhxEWIus
    xsQpuQcIFhxEWIus
    QbVDE4tKFanEFYNh

    • Remove the screws using the screwdriver.

    • Since the screws that hold the motherboard in place are smaller, the screwdriver is able to pick them up.

  10. YBV4Rg6q25Dk6Z3U
    YBV4Rg6q25Dk6Z3U
    XKtis5XdvetVSY4s

    • Carefully remove the motherboard with your hand by lifting it from the device.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

[deleted]

Member since: 17/02/16

679 Reputation

0 comments