Introduction

Can’t hear anything when on a phone call with your OnePlus Nord N20 5G (Model Number - CPH2459) and it isn’t on speaker?

Use this guide to help you replace the earpiece speaker in your OnePlus Nord N20 5G.

Be cautious as you use an iOpener in step 2. Follow these instructions for heating the iOpener.

  1. anXaSLATtEHZpVMr
    • Insert the SIM ejection tool or a spudger in the small hole next to the SIM tray.

    • Push it gently until the tray pops out.

    • Remove the SIM card tray by sliding it outwards.

  2. YhRmYEQcPl4VwZDt
    YhRmYEQcPl4VwZDt
    lTcaPHvXOmiJXjOP
    • Heat the iOpener in a microwave for about 30 seconds. If the iOpener isn’t hot enough, reheat it for another 10-30 seconds.

    • Apply the heated iOpener on the backside of the phone for a minute to loosen the adhesive.

    • Use the iFixit opening tool and slide it along the edges of the phone to pry the back panel off.

  3. 43lp6CDHeUlHdYXx
    43lp6CDHeUlHdYXx
    1GfYCpgOg1AIoSMU
    eixoOmLZDBjxd5vF
    • Remove the 18 3.9 mm screws using a Phillips #0 screwdriver.

  4. bqDaTVPTtEsaYXmU
    bqDaTVPTtEsaYXmU
    ZxqP2vbBYLIqxs1R
    • Take the iFixit opening tool and run it along the edges.

    • Separate the back housing from the frame of the screen.

  5. ScVLS2JpEj2vZxVA
    ScVLS2JpEj2vZxVA
    CvS6q2LHCEZVXTjv
    • Disconnect the brackets attached to the motherboard with the help of a spudger.

    • Remove the 2.8 mm screw from the motherboard, using a Phillips #0 screwdriver, being careful not to damage any wires.

  6. kwkGyem1QRTpfTK5
    kwkGyem1QRTpfTK5
    STk3sFJOLNo1PG2L
    42mNGVRo2qxpmkDw
    • Remove the black and white wire from the motherboard using a spudger.

    • Pull back the front facing camera to make removing the board easier.

  7. DuSSF4FIOyJMba3v
    DuSSF4FIOyJMba3v
    lgYWLdYoGXLY265e
    • Using a spudger, pull up the motherboard and remove it from the device.

  8. CUibqR26ojqFjxUU
    • Disconnect the earpiece speaker using a spudger.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Mila

Member since: 26/09/24

219 Reputation

0 comments