PDP Rematch Advanced Trigger Springs Replacement

Written By: Jacob Thomas Wolgamott
  • Comments: 0
PDP Rematch Advanced Trigger Springs Replacement

Difficulty

Moderate

Steps

5

Time Required

5 - 10 minutes

Introduction

If the triggers require extra force or do not return back to their original position the trigger springs need to be removed. This guide will show how to separate the controller and remove both trigger spring on the PDP Rematch Controller.

  1. LhcAJ2xgi66vGuED
    LhcAJ2xgi66vGuED
    sVW1UmPhgtqGMVQb

    • Orient the controller so the back side is facing you.

    • Use a Phillips #000 screwdriver to remove the seven 9 mm screws that secure the back shell.

  2. 2LQ6uh12ACvMVbFy
    2LQ6uh12ACvMVbFy
    afngIcXIHGdqilJl
    ERrqJBfQowMgx5EM

    • Pull apart the controller's front and back shells with moderate force.

    • Orient the controller so that the front shell is facing the floor to prevent the face buttons from falling out.

  3. ZULEeEPmcKepvspo
    ZULEeEPmcKepvspo
    bKb5GHZ1jX6dCTss

    • Twist the thumbstick to remove it from the motherboard.

  4. NGLH14xoVmpwLBeo
    NGLH14xoVmpwLBeo
    4LgQnYnMmMcJI2rk
    mPHZJNxURhNakVfF

    • Use a Phillips #000 screwdriver to remove the two 5 mm screws that secure the motherboard.

    • Remove the motherboard from the back shell using moderate force.

  5. 5K6JIpoAyUFtiCvR
    5K6JIpoAyUFtiCvR
    WQopIFD5HAA5UEqR
    UoYtEJ4nRtLLkFPk

    • Punch out the metal pin holding in the trigger and the trigger spring. Repeat for both triggers.

    • Remove the trigger and the trigger springs.

    • Using a punch or a small tool allows pin removal to be easier.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Jacob Thomas Wolgamott

Member since: 23/09/24

121 Reputation

0 comments