ResMed VPAP Auto 25 Blower Unit Replacement Replacement

Written By: Camille Simmons
  • Comments: 1
ResMed VPAP Auto 25 Blower Unit Replacement Replacement

Difficulty

Moderate

Steps

6

Time Required

1 hour

Introduction

The blower unit fails when the device becomes overused and outdated. It also fails as a result of dust clogging up the intake. Replacements extend for only a certain amount of time. Replacing the blower unit will save lots of money compared to buying a whole new unit. Eventually, a full unit replacement is necessary.

  1. 1XXZaqT1dlGHhgWn
    1XXZaqT1dlGHhgWn
    OYf2dJCPFHQQQOUy
    1V3G2RYmuVQIsatG

    • Remove the four 26.7 mm T3 Torx screws from the bottom side of the ResMed VPAP Auto 25.

  2. RtAKIVCxLPnWREMS
    RtAKIVCxLPnWREMS
    hAwwb1hU16ZVf2a1
    cJgnslvcHxBPPYLm

    • Flip the device over.

    • Pry the outermost plastic cover off with the metal spudger until the cover is loose and able to be removed.

  3. fYNU1H4sKuMOn2hp
    fYNU1H4sKuMOn2hp
    nVu25oIC4uHo1VWf

    • Pull off the front cover to reveal the internal components.

  4. 5K5IULXSVopIHHBo
    5K5IULXSVopIHHBo
    EToEdZ12jWJgR1tO
    sODOCXF2rmOJaryB

    • Loosen the motherboard from the rubber dowels holding it in place and unplug the screen components.

  5. iTUlMe5UfBrOR5Ax
    iTUlMe5UfBrOR5Ax
    vPgAMCXIah4W6epP
    KYMoAZDhPFpHkv5h

    • Remove the three 26.7 mm T3 Torx screws from the now visible rubber fan motor cover.

    • Lift off the rubber fan motor cover, revealing the fan motor.

  6. dg1dJ5XLhpQPU1gc

    • Unplug the blower unit cable.

    • Remove the fan motor blower unit.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Camille Simmons

Member since: 17/09/20

154 Reputation

One comment

where can we get a new motor?

ed allen -