Ridgid R82005 LED Light Replacement

Written By: Andrew McPherson

Comments: 0

Difficulty

Easy

Steps

Time Required

10 minutes

Introduction

This guide explains and guides you through the process of replacing the LED flashlight found on the Ridgid R82005. If The LED on your Ridgid R82005 is malfunctioning or has stopped working, then it is likely that the light included needs to be replaced. The replacement of this part will require the disassembly of the product therefore it is advised to handle the parts with care as you remove them.

Tools

Step 1

Eject the battery from the drill.
Unscrew the seven M3x15.3mm screws, with the 2mm hex screwdriver bit, that secures the Housing Assembly.

Step 2

Push the metallic Housing Connecting clip out with flat side of the plastic opening tool.
Eject battery before attempting this step.

Step 3

Remove the top half of the Housing Assembly.

Step 4

Grasp carefully the top and bottom of drill components.
LED light needs to be manually removed.
Lift and transfer, as a whole, the drill components from the old housing assembly to the new housing.
Make sure all drill components fit properly in the grooves of new Housing Assembly.