Ring Video Doorbell Battery Replacement

Written By: Abdulrahman
  • Comments: 7
Ring Video Doorbell Battery Replacement

Difficulty

Moderate

Steps

2

Time Required

5 - 10 minutes

Introduction

In this guide, you will be shown how to take apart the housing unit in order to replace the battery of the Ring Video Doorbell, step-by-step. You will need only a Plastic Tool Opener for this.

  1. HZbPuQTkcThKALLZ
    HZbPuQTkcThKALLZ
    5EAvsYeNPHcnZ54L
    ZEtupMwjRTwFbCWB

    • Start by using the PH00 Phillips Screwdriver to take out the 6 1 mm screw's on the bottom of the device.

    • Pry open the aluminium plate using the Plastic Opening Tool(s).

    • Remove the 2 1. mm screws using the PH00 Phillips Screwdriver.

  2. qSGSRpNCaTgai3Ei
    qSGSRpNCaTgai3Ei
    sDDxPFQ1NYOuNBJ3
    uyZVDJSZ5l1jiTpy

    • Pry open the back case as shown using the Plastic Opening Tool.

    • Do NOT lift the case of all the way, there is still a cable connecting the two pieces.

    • Disconnect the battery from motherboard by carefully pulling up on the connector.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Abdulrahman

Member since: 20/02/18

709 Reputation

7 comments

Where do I get a replacement battery?

William Price -

I had an issue where the battery would not charge the light when I was trying to charge the battery flashed bue quickly, I removed the battery and found that the connector was corroded after cleaning it and making sure it was connected correctly the battery then took a full charge and now the bell functions as intended once again.

P.S thanks for the guide :)

David Haras -

Who should the complete unit be sent to for checkup and repairs as it does not work

d.rayyan -

can it be sent to the manufacturers for a replacement

d.rayyan -

similar to David, I pulled off the battery connector and reattached it, then sealed with some rubber cement. Unit immediately went back online.

Daniel Wise -

Thanks for the guide. NOTE TO OTHERS: the battery connector pins are very fine and fragile, and truly a challenge to reconnect. be sure to try to pry up the connector straight up, else the pins will bend over, then good luck reconnecting!

Dan Elliott -

Front door bell camera no longer works. Tried everything, no results. Is there anything special I need to do to trash the darn thing and install a regular doorbell?

James D Birmingham -