Ring Video Doorbell Housing Replacement

Written By: Abdulrahman
  • Comments: 2
Ring Video Doorbell Housing Replacement

Difficulty

Moderate

Steps

4

Time Required

25 minutes

Introduction

In this guide, you will be shown how to take apart and replace the Housing unit of the Ring Video Doorbell step-by-step. You will need a Phillips screwdriver size PH00 and a Plastic Tool Opener.

  1. 2H3gXlOtXXHYBPSW
    2H3gXlOtXXHYBPSW
    AXJtYbjrHQAf6l4m
    lhi4TAZshVZd6QJG

    • Start by using the PH00 Phillips Screwdriver to take out the 6 1 mm screw's on the bottom of the device.

    • Pry open the aluminium plate using the Plastic Opening Tool(s).

    • Remove the 2 1. mm screws using the PH00 Phillips Screwdriver.

  2. jcduLOmGvcGGXpaE
    jcduLOmGvcGGXpaE
    nP4mxQgJSKFqiMYk
    SFSnSwiDm5TgUSH6

    • Pry open the back case as shown using the Plastic Opening Tool.

    • Disconnect the battery from motherboard by carefully pulling up on the connector.

  3. 5NIsgwXmiJHGxvEm
    5NIsgwXmiJHGxvEm
    xOOWbNxZDIiMoc25
    BGUdEr66tobGmUwn

    • Unscrew the 9 1 mm screwdrivers using a PH00 Phillips Screwdriver.

    • Carefully detach the motherboard, from the housing unit using your hands.

  4. bEFJHjKuFa5vXNUl

    • Remove the plastic film using the Plastic Tool Opener.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Abdulrahman

Member since: 20/02/18

709 Reputation

2 comments

Hey, do you know if Ring will provide you with replacement front housing? My casing has been damaged by an attempted theft :(

Charlie Adamson -

Hello need rear panel that battery sits on 1st generation thanks

Jerry Narain -