Introduction
If you need a new analog because yours is jammed and dirty, then this is where you need to be. On this replacement guide our team will be fixing the analog stick on a SAFFUN Wireless N64 Controller. For this replacement you will need a 3.5 fixit screw driver, a 1.5 Jakemy screw driver, and a soldering tool. There aren't any difficult steps in this replacement, just follow along!
Tools
-
-
For step 1, I used a 3.5 screw driver to unscrew the 7 base screws and 1.5 screw driver to unscrew the 2 upper screws.
-
-
-
For step two, we used the same 3.5 screw driver to unscrew the 3 screws around the component.
-
Then we unscrewed the three screws on the component.
-
-
-
For step 3, we used a soldering tool to etch off the board.
-
We took off all three sides as you can see in the photos.
-
-
-
After doing that, we replaced the piece and put it back together.
-
We screwed the screws back into the back and pushed the front and back pieces together. Now the analog is successful
-
To reassemble your device, follow these instructions in reverse order.
