Samsung Galaxy Z Flip 4 Display Replacement

Written By: Massimo
  • Comments: 3
Samsung Galaxy Z Flip 4 Display Replacement

Difficulty

Moderate

Steps

11

Time Required

30 minutes - 1 hour

Introduction

This guide will show you how to replace the screen of your beloved Samsung Galaxy Z Flip 4.

You'll need the following tools:

  • iOpener/Heatgun
  • Phillips #00 screwdriver
  • Spudger
  • Multiple Picks
  • Suction cup

  1. WYaTMSroWXqYJYvy

    • Make sure your phone is turned off before starting this guide.

  2. kgxWwZALye5Xvkhs
    kgxWwZALye5Xvkhs
    dH6wVwUFqIqNYrFU
    OgNlpT1ZUsPISmMi

    • Get your iOpener/Heatgun and start by heating up the bottom back cover.

    • Start heating around the edges and place your suction cup. When heated enough, you should be able to insert a pick between the frame and the back glass.

    • Go around the frame and cut all the glue to remove the back cover.

  3. 56mN63N512eLbTyJ
    56mN63N512eLbTyJ
    AToMuUuQCeTIOKbf
    M6U2sSdGlbB1RJLp

    • Get your iOpener/Heatgun and start by heating up the upper back cover.

    • Start heating around the edges and place your suction cup. Be careful of the display when heating. When heated enough, you should be able to insert a pick between the frame and the back glass.

    • Go around the frame and cut through all the glue to remove the back cover. Be careful not to cut too deep into the glue to avoid damaging the display.

    • Finally, remove the plastic clip that holds the secondary display connector in place and unplug the cable with a pair of pliers.

  4. tGM5wZG1tYNjdCpj
    tGM5wZG1tYNjdCpj
    pn5aZF6oDYTpgqGN
    YMP1wL4xucKSf2MS

    • Unscrew the cover that covers the main battery and wireless coil connectors.

    • Disconnect the connectors and remove the charging coil.

  5. WuNGEIboTyynZIrr
    WuNGEIboTyynZIrr
    YI45jIlOjHbYZVXD
    pHpWPvbmaLMuxCF6

    • Remove the two screws holding the cover for all connectors on the motherboard.

    • Disconnect the battery and all other connectors.

  6. LnemZc3cHc5GoeNn
    LnemZc3cHc5GoeNn
    XPYcRCMtCVJhPKnR
    YjPX3SbA6noJwEOK

    • Remove the 4 screws holding the speaker cover in place.

    • Lift it with a spudger to remove it.

  7. riBJMObXfosIpIrq
    riBJMObXfosIpIrq
    th1rHIZbBwinwgvv
    dflJDt4SiXovLYbJ

    • Disconnect the two cables on the top of the charging sub-board.

    • Remove the two remaining screws holding the board in place.

    • Before you can remove it, flip it over and remove the last remaining connection to the display assembly.

  8. G5fYvfGXbswNuAqS
    G5fYvfGXbswNuAqS
    VYnNnFTLpLL4sp6H
    4mUHdoj3fPvmyYsC

    • Remove the 5 screws holding the top cover and remove it with a spudger.

  9. 4sGGIDEPiMYAFr4N
    4sGGIDEPiMYAFr4N
    es5F4NID2TABvrik
    fVeq3nUISMlXxAsD

    • Unscrew the last screw holding in the logic board, next to the cameras.

    • Remove the SIM tray

    • Lift out the logic board with a spudger.

  10. NCZt144DaEO5bJDi
    NCZt144DaEO5bJDi
    UNXwKjpka5ppk6Xx

    • This can be a little tricky since the camera is glued in.

    • Heat up the display where the front camera is located

    • Try lifting the camera out with tweezers.

  11. RGOsqRYfXYVeJXsQ
    RGOsqRYfXYVeJXsQ
    mmf1OxoXtOSq2uRG

    • Use isopropyl alcohol to loosen the adhesive on the battery. Pour some Isoprop into the space between the battery and the frame.

    • Wait about 30 to 60 seconds for the alcohol to work, then lift the battery with a spudger.

    • Repeat the same procedure for the secondary battery.

Conclusion

You did it!

To reassemble your device, follow these instructions in reverse order.

Author

Massimo

Member since: 12/11/21

508 Reputation

3 comments

Have done this. but when turning the Flip on, the Galaxy logo shows up, then it shows the desktop and asks for pin code for half a second and then goes black. After that it will not turn back on again, the small screen on the back says there is something wrong. What could be wrong then?

Puterfreak -

same problem, did you find the solution ?

rrtech -

Sadly, no luck, no

Puterfreak -