Shark Apex DuoClean Powered Lift Away AZ1002 Foam and Felt Filters Replacement

Written By: Nonhle ( Nonny) Mthethwa
  • Comments: 0
Shark Apex DuoClean Powered Lift Away AZ1002 Foam and Felt Filters Replacement

Difficulty

Easy

Steps

6

Time Required

10 minutes

Introduction

Continued use of the Shark Apex DuoClean Powered Lift-Away (Model-AZ1002) can lead to loss of suction.If your vaccum is experiencing an issue with picking up debri , follow the steps of this guide to clean and/or replace the filter.

  1. Fm5cuS5mFvGFqCnk
    Fm5cuS5mFvGFqCnk
    2HeiMKK1s4y1TEwM

    • Press the dust cup release button.

  2. SXMVWmJgRdAuEJGE

    • Use the handle to pull the dust cup away from the wand, then lift upwards to fully free the cup.

  3. LiTEan3sjgP2ZcaR
    LiTEan3sjgP2ZcaR
    ZTSEIUK6TOJELrF5
    T261DGBVxAtTZe1D

    • Pull the filter tab up to remove the large white foam filter and circular thin form at the bottom.

  4. xUlwFvhJM5xfmlqW
    xUlwFvhJM5xfmlqW
    UbHkLPbGruRaekeT

    • Remove the white foam filter.

    • Go to a trash bin and shake both filters to remove loose dirt carefully debris.

  5. nhc3D2xYrIvkpPJP
    nhc3D2xYrIvkpPJP
    PA4TrIs3ncSgfJdr

    • Rinse the filters thoroughly under lukewarm water until the water runs completely clear.

    • Avoid using hot water, as it can damage the filters.

  6. f2ng1ReOJZ3Qeprs

    • Allow the filters to air dry completely before reinserting them in the vacuum.

    • If the filters are not left to completely dry before replacing them in the vacuum, lingering water can cause the filters to mold.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Nonhle ( Nonny) Mthethwa

Member since: 05/02/24

183 Reputation

0 comments