Sonos Five Midwoofer Replacement

Written By: Nicholas Ouimet
  • Comments: 3
Sonos Five Midwoofer Replacement

Difficulty

Moderate

Steps

6

Time Required

No estimate

Introduction

  1. F2aNQQ1tPaqyolXZ
    F2aNQQ1tPaqyolXZ
    kQAZKEQcEELUEPoa
    sJAIVFtGW3yfZpQI

    • Use a thin guitar pick to carefully pry up on the grill

    • Be sure the pick is being wedged between the side of the casing and the rubber grill frame, and not the plastic mesh itself!

  2. Bm6NiAYKmjuIjDXR
    Bm6NiAYKmjuIjDXR
    Gcel3MooNFO5PZip
    BDX2gJnk4iRAiLgA

    • Continue freeing the grill

    • Make sure to note the circled posts when reinstalling to prevent damage

    May need additional guidance here on handling the sonos logo + pause play button in the center. I believe this is a single piece attached to both the case and grill and I was not sure how to remove.

    Michael Manes -

  3. gFnZWGV5HtXAqUeT
    gFnZWGV5HtXAqUeT
    D2mQfmEgBow2MDNs
    4cD5btmUx3RRoSD5

    • Remove the four T20 screws securing the driver to the front panel.

    • Be sure to align the speaker properly with it's alignment posts during reinstallation (third photo)

  4. ZX2AVFX3PIJUU3eZ
    ZX2AVFX3PIJUU3eZ
    ltUPXeUN6HhYyKyY
    JKtIa1WsMVWSYYB1

    • The insulated terminal simply disconnects

    • The non insulated terminal has a tab that must be depressed to remove.

    • Remove the midwoofer from the unit

  5. YnZ2ODNmBEofOsGN
    YnZ2ODNmBEofOsGN
    EGxoWP6RkAAfZJoS
    TesOUjFRJsR6n4Ig

    • Remove the four T20 screws securing the driver to the front panel.

    • Lift the midwoofer out of the cabinet slightly to disconnect the terminals

    • The center midwoofer driver wires are extremely short. Care must be taken to not strain the wires. This is a two handed operation of holding the driver while disconnecting the terminals

    • The insulated terminal simply slides off, but the non insulated terminal has a locking tab that must be depressed.

  6. PDPfmFcuLILnEno5
    PDPfmFcuLILnEno5
    Sq443fXCqtXpvFxN
    TtqsKf2gW1kTKf4v

    • Remove the four T20 screws securing the driver to the front panel

    • Lift the driver out of the cabinet.

    • The left noninsulated terminal has a locking tab that must be depressed. The right terminal simply pulls off

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Nicholas Ouimet

Member since: 17/10/09

3548 Reputation

2 comments

Hola sabes donde podría comprar los parlantes tengo un somos five y están las tres bocinas reventadas

Ricardo.tranamil.h@gmail.com

Ricardo tranamil -

Hola nesecito comprar las bocinas de repuestos por favor

Ricardo tranamil -